In very high frequency performances such as spacecraft, satellite & missile applications where the size, weight, cost, performance, ease of installation & aerodynamic profile are constraints microstrip antennas (MA) are used to meet these requirements. In spite of limitations such as small bandwidth, low gain and low power handling capability, microstrip antenna offers good performance over oth...

Computation of the broadband matching potential of a microstrip antenna requires the wideband lumped equivalent circuit of the antenna. The general topology of the equivalent circuit of rectangular microstrip patch antennas has been used to model the feedpoint impedance of microstrip antennas over a wide frequency band and equivalent circuit parameters are determined using optimization techniqu...

This paper presents modeling of annular patch antenna. The S and Z parameters of an Annularpatch Microstrip antenna are investigated and optimization. The optimization is performed byvarying the inner and outer radius of annular Ring. The impedance and radiation characteristicsof annular patch antenna are examined and compared. It is able to achieve a return loss lessthan -36 dB...

In recent years, great interest was focused on microstrip antennas for their small and good performance. With the continuous growth of wireless communication communication equipment, there are higher and higher demands feed single layer compact rectangular microstrip antenna application is proposed in this paper. Two L slits are introduced at edge of the patch to reduce the resonant frequency. ...

Abstract— This paper describes 2 x 2 triangular microstrip patch antenna using T-junction with quarter wave transformer. By regulating the distance in patch antenna and adjusting feed position, bandwidth can be obtained and by using an array, directivity is enhanced. The requirement of large bandwidth, high directivity, and minimum size leads to the design of 2 x 2 triangular microstrip patch a...

Microstrip patch antennas can be fed by a variety of methods. These methods can be classified into two categoriescontacting and non-contacting. In the contacting method, the RF power is fed directly to the radiating patch using a connecting element such as a microstrip line. In the non-contacting scheme, electromagnetic field coupling is done to transfer power between the microstrip line and th...

Abstract—The patch shape influence on the radar cross section (RCS) of a cylindrical microstrip antenna (CMA) is discussed. The RCS of the CMA is evaluated from a plane wave scattering problem solution to a cylindrical microstrip antenna. The method of moments is employed in the spectral domain using sub-domain basis functions. It is shown that the patch shape has a pronounced effect such that ...

The low cost, high efficiency, single-feed microstrip antenna with a two-layer substrate for circular polarization (CP) is presented. A new CP design of a singlefeed nearly square patch with two truncated square corners is also described here. The two-layer substrate consists of an FR4 dielectric layer and a foam layer. The effects of the foam substrate on the impedance bandwidth, axial ratio, ...

The compact variation of equilateral triangular microstrip antenna, a shorted 600 Sectoral microstrip antenna is discussed. The proximity fed shorted 600 Sectoral microstrip antenna is proposed which gives simulated and measured BW of more than 700 MHz (>60%). To increase the bandwidth and gain, gap-coupled configuration two Shorted 600 Sectoral patches is proposed. It yields simulated and meas...

In this paper a novel design of small sized, low profile coaxial fed microstrip patch antenna is proposed for terrestrial DTV signal reception applications in the UHF band frequency range of 540-890MHz. Designed model was spiral slot microstrip patch antenna using shorting plates for size reduction. Different parameters like return loss, VSWR, gain along θ, Ø directions, radiation pattern in 2D...