This paper presents a three-phase four-wire Shunt Active Filter that compensates power quality problems and can also interface renewable energy sources with the electric grid. The inverter stage of the active filter is based in a two-level four-leg inverter and its control is based in the Theory of Instantaneous Reactive Power (p-q Theory). The filter is capable of compensating power factor, un...

Electrolytic capacitors are a bottleneck for inverter lifetime. Because of the large capacitances used in PV-inverters, a direct replacement by film-capacitors is not feasible for most topologies. This paper presents an active circuit which acts as an interface between the DC-link of a PV-inverter and an additional storage capacitor. By allowing a large voltage ripple at the storage capacitor, ...

This work deals with the design and implementation of a training module for three phase induction motor control, which was divided in the design of: the isolation stage, the drivers, the power inverter and the control source. The simulation was carried out in Matlab to determine the system behavior and for the generation of the waveforms which is finally implemented using the VHDL code in the c...

This paper presents an optimization of the electric power quality by designing a 9 steps multilevel power inverter, which adopts a multi-PWM optimized using genetic algorithms (GA), and minimizing Total Harmonic Distortion (THD) of the first 50 harmonics to about 0%. This optimization is considered an alternative technique because it reduces the expression used to quantify TDH numerically. Part...

In this paper, a seven level modified cascaded multilevel inverter is proposed for industrial drive applications. Apart from selecting the conventional level inverters, Multi level inverters has been chosen for the industrial drive applications as it reduces the total harmonic distortion. The involvement of higher number of switches increases the complexity of the system, which leads to losses ...

Abstract –In this paper, proposes an analysis and design of a high efficiency boost-inverter with battery storage in fuel cell. When low-voltage unregulated fuel cell (FC) output is conditioned to generate AC power, two stages are required. The boost-inverter topology that achieves both boosting and inversion functions in a single-stage is used to develop an FC-based energy system which offers ...

DC-BUS based power distribution systems with battery backup have been widely used in aerospace and telecommunication applications, where the bus voltage is usually determined by the battery. In these systems, there are many loads that need different and low operating voltages. Since the bus voltage is usually much higher than the load voltage and varies in a wide range with the stage of charge ...

Abstract: A stand-alone multi-microgrid (MMG) system can be formed by connecting multiple stand-alone microgrids (MGs). In the stand-alone MMG system where the frequencies of each MG system are different, a back-to-back (BTB) converter can be used for interconnecting the adjacent MG system. The frequency control performance of the MMG system can be improved by designing the suitable controller ...

In recent years, Electrical Bioimpedance (EBI) methods have gained importance. These methods are often based on obtaining impedance spectrum in the range of β-dispersion, i.e. from a few kHz up to some MHz. To measure EBI a constant current is often injected and the voltage across the tissue under study is recorded. Due to the performance of the current source influences the performance of the ...

The voltage source inverter (VSI) and current voltage source inverter (CSI) are widely used in industrial application. But the traditional VSIs and CSIs have one common problem: can’t boost or buck the voltage come from battery, which make them impossible to be used alone in Hybrid Electric Vehicle (HEV/EV) motor drive application, other issue is the traditional inverter need to add the dead-ba...