the thermo-hydraulic behavior of the air flow over a two dimensional ribbed channel wasnumerically investigated in various rib-width ratio configurations (b/h=0.5-1.75) atdifferent reynolds numbers, ranging from 6000 to 18000. the capability of differentturbulence models, including standard k-ε, rng k-ε, standard k-ω, and sst k-ω, inpredicting the heat transfer rate was compared with the experi...

The internal flow circulation dynamics of a liquid drop moving in a co- or counter-flowing gas stream has been numerically studied. The present work is concerned with the time accurate numerical solution of the two phase flow field at the low Mach number limit with an appropriate volume tracking method to capture motion and deformation of a liquid drop. It is shown that relative velocity betwee...

During the pneumatic conveying of plastic pellets, it has been observed that materials with similar physical characteristics may develop a substantial difference in pressure drop. In this work, the pressure drop in a particle-laden 2.7 meter long horizontal channel with circular cross-section is presented from an experimental perspective. Experiments are carried out for cylindrical polystyrene ...

A highly efficient technique of contaminant gas reduction, Turbulent Contact Absorber (TCA), is applied to CO2 removal from a typical flue gas. Aqueous K2CO3 sorbent was evaluated as a regenerable sorbent for CO2 from the flue gas. In order to identify the system, momentum and mass balance equations were written for the TCA tower. A flat plate falling film model was employed to simulate the TCA...

The combined cycle power plant is made up of three major systems, the gas turbine engine, the heat recovery steam generator and the steam turbine. Of the major systems the gas turbine engine is a fixed design offered by a manufacturer, and the steam turbine is also a fairly standard design available from a manufacturer, but it may be somewhat customized for the project. In contrast, the heat re...

The hydrodynamic description of trickle flow is a complex field of study. One of the main contributors to the complexity is the existence of multiple hydrodynamic states (MHS). As early as 1978, Kan & Greenfield reported different pressure drop and holdup readings for the same liquid and gas feed rates. The study revealed that the flow history experienced by the bed determined the specific hydr...

Considering the disadvantages of gasoline and natural gas as mono-fuel in SI engines has made the researchers to improve the performance and reduce the pollutant as the advantages of the application of dual fuel engines. On the other hand, lean-burn in engine may lead to the reduced pollutant. In the present study various mixtures of gasoline and natural gas with the gasoline as the dominant fu...

Industrial systems at where gas-liquid flow is extensively used generally have complex geometries including singularities like expansion, contraction, bends and orifices. Thus two-phase flow characteristics, such as pressure drop, through these singularities should be identified in order to be used to design these systems. In this study, pressure drop of air-water flow through horizontal channe...

The effective surface area ae of 14 variants of three highly effective types of packings (IMTP, Raschig Super-Ring (RSR) and Ralu-Flow) made of stainless steel or plastic is investigated as a function of the liquid superficial velocity. The packing size varied from 20 to 70 mm, and the liquid superficial velocity from 5 and 200 m/(mh). The comparison of the obtained data shows the following: Am...

constructing phase diagram and its subsequent quality lines for lean gas condensate reservoirs is always crucial and challenging topic in reservoir fluid studies. due to small amounts of liquid drop-outs in lean gas condensates at reservoir conditions, full experimental tracking of phase diagram and its relevant quality lines is almost impossible for lean gas condensates.on the other hand, eos ...