Using ground granulated blast-furnace slag (GGBS) under different alkaline conditions, we studied the mechanisms and extents of Cr(VI) reduction and sorption and compared them to reactions with Portland cement (PC). We also investigated the effects of mixing PC/GGBS ratios on Cr(VI) dissolution after carbonating the substrates. We observed a complete sorption and reduction of Cr(VI) to Cr(III) ...

The extensive use of Portland cement (PC) in the manufacturing concrete is responsible for depletion natural resources that are part production. Cement supply permanently threatened by ongoing materials, including sand, limestone, and clay. Concurrently, incineration agricultural residues presents a significant ecological problem. This study explores substitution with 5%, 10%, 15%, 20% wheat st...

During the hydration of cement, tricalcium aluminate (C3A) reacts with gypsum and forms ettringite (AFt). Once all gypsum is consumed, ettringite can further react with remaining C3A and form monosulfate (AFm) at 1–2 days. Normally, at early ages, ettringite all transfers to AFm phase. After several months or years, ettringite can form again if a new source of sulfate becomes available in the p...

An investigation was carried out to establish the physical, mechanical and chemical characteristics of a non-standard (unprocessed) pulverised fuel ash (PFA) and waste tyres from a former landfill site at the Power Station Hill near Church Village, South Wales, United Kingdom. Investigations are on-going to establish the suitability of the fly ash and/or tyres in road construction (embankment a...

In this paper, an ultrasonic shear wave reflection method was adopted to mimic the microstructural evolution of hydrating Portland cement pastes with different water/cement-ratios (0.35, 0.5 and 0.6) cured under a constant temperature of 25°C. The reflection coefficient measured with this technique was correlated to microstructural parameters of the cement pastes. The application of numerical s...

INTRODUCTION The purpose of our study was to evaluate the antibacterial effect of ProRoot MTA (PRMTA), Root MTA (RMTA) and Portland cement (PC) at their clinical concentration (70 mg/25 µL) against Actinobacillus actinomycetemcomitans (Aa) one of the prominent periodontal (pocket) microorganisms. MATERIALS AND METHODS Agar diffusion test on Blood Agar with Hemin and Vitamin K (BAHV) was emplo...

INTRODUCTION To determine and compare the pH, conductivity and calcium release of an experimental Portland cement (PE) consisting of trioxid mineral aggregate and a comercially available modified Portland cement (C.P.M.) after 1, 2, 3, 4, 8, 10, 15 and 30 days. MATERIAL AND METHODS Cements were mixed following the manufacturer's instructions, with a powder: liquid ratio of 3:1. Each cement wa...

In this study, the amount of cement used in a concrete mix is minimized to reduce the toxic effects on users by adjusting the concrete mixture contents. The reduction of cement is achieved by using various admixtures (ground granulated blast-furnace slag, flyash, ordinary Portland cement, and activated Hwangtoh powder). To apply the mix to construction, material property tests such as compressi...

Fiber reinforced concrete is a composite material consisting of mixtures of cement, fine aggregate, coarse aggregate and fibers. The fiber reinforced concrete exhibits better fatigue strength and increased static and dynamic tensile strength and compressive strength. In this project, the strength of fiber reinforced concrete was investigated partial replacement of cement with rice husk ash and ...