The article investigates the numeric simulation of two-way aeroelastic processes applied to the experimental phase of a compressor; physical, mathematical, rigid and grid models of the system “gas – rotor – stator” have been worked out; 2 FSI (two-way Fluid-Structure Interaction) calculations have been performed on the evaluation of the interaction between a gas-dynamic flow and a deformable ro...

In this paper direct power control (DPC) strategy is applied to control a doubly fed induction generator (DFIG) based wind energy generation system. A AC/DC/AC converter is controlled by direct power control method. The rotor side converter is controlled by selects appropriates voltage vector based on the instantaneous errors between the reference and estimated values of active and reactive pow...

The paper demonstrates simulation and steady-state performance of three phase squirrel cage induction motor and detection of rotor broken bar fault using MATLAB. This simulation model is successfully used in the fault detection of rotor broken bar for the induction machines. A dynamic model using PWM inverter and mathematical modelling of the motor is developed. The dynamic simulation of the sm...

in this research, the steady-state flow filed around a 3d body and rotor configuration of the robin helicopter is simulated. the rotor is modeled by an actuator disk. for this purpose, an annular computational domain replaces the rotor and some modeled source terms are added to the momentum equations. this modeling of rotor considerably speed up computational time. the flow field over this heli...

in this research work with the aid of tagouchi experimental design and rawing of interaction curves with minitab software, the best rotor speed and dump temperature of mixing for physico-mechanical and rheological properties of the rubber compound with three mixing steps was obtained. moreover by plotting the mean curves in excel worksheet, the dependency of properties on rotor speed, dump temp...

Small rotor clearances are today a vital prerequisite for an efficient screw compressor. The clearances are responsible for compressor leakages, small clearance will minimise them and thereby increase both, the volumetric and adiabatic efficiency. A continuous improvement in the rotor manufacturing equipment has been achieved during the recent years and tight production tolerances may now be ap...

Rotary-wing flying machines draw attention within the UAV community for their in-place hovering capability, and recently, holonomic motion over fixed-wings. However, they still fall behind in terms of the flight time, power consumption, and safety for centrally-powered and redundant multi-copters have been suggested and studied. In this paper, we investigate about the power-optimality in a mono...

A theory of dynamic angle spinning (DAS) and double rotation (DOR) NMR is described using average Hamiltonian and irreducible tensor methods. Sideband intensities in DAS and DOR spectra are analyzed by both the moment and Bessel function methods, and general formulae are derived. Results show that the DAS moments depend on the relative rotor phase between the first and the second evolution peri...

Unbalance in magnetically levitated rotor (MLR) can cause undesirable synchronous vibrations and lead to the saturation of the magnetic actuator. Dynamic balancing is an important way to solve these problems. However, the traditional balancing methods, using rotor displacement to estimate a rotor’s unbalance, requiring several trial-runs, are neither precise nor efficient. This paper presents a...

The direct torque controlled (DTC) permanent magnet synchronous motor (PMSM) has become attractive because of its simplicity and fast torque response. However, mechanical sensors have caused problems to the system. It is possible to overcome the disadvantage if the initial rotor position is known. For the initial rotor position detection, the structural and magnetic saturation saliencies are fr...