After gas atomization, a quasicrystalline powder based on aluminium was used to prepare a thick coating by high-velocity oxygen-fuel flame torch spraying. This layer was deposited on top of a bond-coat layer on a steel plate. A post-spraying annealing treatment turned the two layers to their stable state, a γ-brass crystal and an icosahedral quasicrystal, respectively. The projection parameters...

Vermicular graphite cast iron, which is widely used in the automotive industry because of outstanding strenght properties. But, there are many problem with regard to machinability of this material. In this study, optimum cutting parameters were studied in order to improve machinability of vermicular graphite cast iron. Experiment parameters which is appropriate for ISO 3685 was selected. Depend...

Recently the synthesis of ultrafine powders has drawn considerable attention because these powders can have physical and chemical properties superior to those of bulk specimens. In particular, emphasis is on the preparation of ultrafine ceramic powders for their applications in the development of sintered products having higher density and lower sintering temperature. One such industrially impo...

Silicon carbide is one of the most promising materials for power electronic devices capable of operating at extreme conditions. The widespread application of silicon carbide power devices is however limited by the presence of structural defects in silicon carbide epilayers. Our experiment demonstrates that optical second harmonic generation imaging represents a viable solution for characterizin...

Our present work presents a direct association of the observed loss of shear strength in boron carbide under plane shock wave compression to amorphization in boron carbide under triaxial stress compression. This evidence is obtained from in-situ measurement of Raman, and infrared vibrational spectra of boron carbide confined in a Diamond Anvil Cell (DAC) under hydrostatic and non-hydrostatic pr...

Carbide composites are materials based on the carbide phases of the refractory or high melting temperature metals. The hard carbide phase (WC, TiC) is usually embedded into soft matrix – pure metals (Fe, Co, Mo, Ni and others) or their combinations. The hard phase supports high hardness and strength of the carbide composites, while matrix is needed for toughness and plastic properties. The ordi...

Microsilica, or silica fume, is an amorphous type of silica mostly collected as byproduct of the silicon and ferrosilicon alloy production. In this work, low shrinkage alumina-mullite ceramic composites were prepared from mixtures of calcined alumina, silica fume and aluminum metal powder and sintered at 1550 o C for 2 hrs. The influence of silica fume and aluminum powder on the densification p...