[1] Steam explosions, or littoral blasts, generated when pyroclastic flows interact with seawater may be a common, although rarely documented, phenomena. The development of steam explosions rather than passive steam production is related to the rate of thermal energy transfer from hot pyroclasts to water. We conduct a series of laboratory experiments to quantify the heat transfer and steam prod...

In power station practice, work is extracted from expanding steam in three stages namely High Pressure(HP), Intermediate Pressure(IP) and Low Pressure(LP) turbines. During the expansion process in the LP turbine, the steam cools down and at some stages, it nucleates to become a two-phase mixture. It is well-acknowledged in the literature that the nucleating and wet stages in steam turbines are ...

Steam-water flow exists in most geothermal reservoirs where steam-water capillary pressure plays an important role in controlling fluid distribution, transfer of liquid between fracture and matrix, well productivity, and even the reserves. However, it is very difficult to measure steam-water capillary pressure due to the phase transformation and the significant mass transfer between the two pha...

Sunlight heats the greenhouse air temperature and tomato cracking decreases marketable product up to 90%. A shade screen reduced incoming radiation during warm and sunny conditions to reduce tomato cracking. A fuzzy controller managed greenhouse irrigation to reduce tomato cracking using as variables solar radiation and substrate temperature. The embedded controller presented 9 rules and three ...

teurizers (1). I f these various precautions are not sufficient to produce a satisfactory steam supply, the alternative is the production of culinary steam from potable water, using the unsatisfactory primary steam supply as a source of heat. The 3A recommended practice just referred to includes a sketch of the recommended location of the parts necessary for such an installation. The other alte...

In this paper, Steam Assisted Gravity Drainage (SAGD) is introduced and its advantages over ordinary steam injection is demonstrated. A simple simulation model is built and three scenarios of natural production, ordinary steam injection, and SAGD are compared in terms of their cumulative oil production and cumulative oil steam ratio. The results show that SAGD can significantly enhance oil prod...

Abstract Simulation of heavy oil thermal cracking process is very important but few researches have been published now. In this paper, a simulation framework based on the carbon number-based approach(CNCA) has been established. A systematic division rule is put forward for dividing cracked products into 59 carbon number components. Then the cracking reaction network has been structured and the ...

The issues of feedstocks, product markets, and environmental emissions have continuously proposed a number challenges for industrial evaluation fresh fluid catalytic cracking (FCC) catalyst before its application in commercial units. In this work, convenient method was by comparing with the existing equilibrium catalyst. A series laboratory experiments steam treatments microactivity tests were ...

The life extension of nuclear power plants beyond 60-years relies on the integrity steam generator tubes during extended life. Alloy 690 have been generally believed to be resistant stress corrosion cracking (SCC) failures until recent unexpected observation intergranular cavities long-term SCC testing. Here, a multi-technique characterisation approach has used study behaviour 30% cold worked s...

The dangers posed by non-condensable gases (NCGs) in steam sterilisation processes have long been underestimated. Biological indicators, or the best chemical indicators on the market, do not signal the presence of a NCG content of up to 10% in a sterilisation process so long as there is mixing of steam and NCGs in the sterilisation chamber. Already back in 1963, Bowie and Dick (1) demonstrated ...