the mechanical behaviour of rockfill materials and aggregates depends not only on particle size and compaction, but also on their strength and lithological properties. in this research two types of large triaxial and direct shear tests are performed on rockfill materials. this paper compares the stress-strain behaviour of sandstone and andesibasalt materials in triaxial compression tests (3006...

in this work, leather fibers were employed as a component of elastomeric compounds based on nbr, cr and epdm and studied were made on their effects upon curing characteristics and mechanical properties of the prepared compounds. evaluation of curing characteristics of the compounds demonstrated that leather fibers have no considerable effect on initial viscosity and curing time of the compounds...

Reinforced concrete is the most commonly used material in construction industry. However, one disadvantage of reinforced that environmental factors cause materials to penetrate and steel bar corrosion. Rebar corrosion increases its volume significantly by approximately 3–6 times, which lowers concrete–rebar adhesion. This severely affects serviceability durability structures. The economic socia...

A study has been made of the compaction properties of two experimental starches, namely yam starch obtained from Dioscorea rotundata and rice starch obtained from Oryza sativa and the mechanical properties of their tablets, in comparison with those of official corn starch. The influences of the physical and geometric properties of the starch particles on the compression properties of the starch...

To investigate the effect of tempering treatment on mechanical properties and the microstructure of DIN 1.4021 Martensitic Stainless Steel, austenite treatment was conducted for the samples at 1000 ºC temperature for 60 min and then the samples were oil quenched. Later, tempering treatments were performed for the samples at 500 ºC and 700 ºC temperatures for 2 and 5 h, respectively; then quench...

Structural steels with very high strength levels are often referred to as ultrahigh-strength steels (UHSS). The usage of UHSS has been extensively studied in aerospace industries and offshore platforms. In this study, medium carbon low alloy steel (AMS6305) was thermomechanicaly treated to obtain an ultra-high strength bainitic steel for aircraft engine compressor disk. A novel themomechanical ...

objective(s): the aim of this study was to synthesis new dental nanocomposites reinforced with fabricated glass nanoparticles and compare two methods for fabrication and investigate the effect of this filler on mechanical properties. materials and methods: the glass nanoparticles were produced by wet milling process. the particle size and shape was achieved using psa and sem. glass nanoparticle...