A numerical and experimental investigation was conducted to analyze dropwise evaporative cooling of heated surfaces with various wettability characteristics. The surface wettability was tuned by nanostructure modifications. Spray-cooling experiments on these surfaces show that surfaces with better wettability have better heat transfer rate and higher critical heat flux (CHF). Single droplet imp...

a thermodynamic analysis of the counter flow wet cooling tower (cwct) in the steelmaking unit of the khuzestan steel company (ksc) is performed in this paper. we evaluated both energy and exergy formulations for analyzing the heat and mass transfer, exergy and second-law efficiency in this cooling tower. the lewis factor le f is an indication of the relative rates of heat and mass transfer in a...

Non-Fourier models of heat conduction have been increasingly considered in the last years in the modeling of microscale heat transfer in engineering and biomedical problems. Models that incorporate time lags in the heat flux and/or the temperature gradient result in heat conduction modeling equations in the form of partial differential equations with delay, while some approximations may yield p...

A new model to calculate heat eddy diffusivity in separating and reattaching flows based on modification of constant Prt is proposed. This modification is made using an empirical correlation between maximum Nusselt number and entrance Reynolds number. The model includes both the simplicity of Prt=0.9 assumption and the accuracy of two-equation heat-transfer models. Furthermore, an appropriate l...

an investigation on the thermal performance of the soil as geothermal heat energy storage medium has been conducted. the thermal characteristics of the soil storage and the heat transfer from a heat exchanger in the soil, surrounding and bottom surface will be discussed. this investigation forms a contribution to a project to realize such storage to be charged from a solar heating system. this ...

in this paper, wavelet collocation method has been used to solve nonlinear fin problem with temperature dependent thermal conductivity and heat transfer coefficient. thermal conductivity of fin materials varies any type so that we consider thermal conductivity as the general function of temperature.  here we consider three particular cases, where we assume that thermal conductivity is constant,...

The potential of nanofluids for the improvement of heat transfer coefficient in various heat exchangeequipment has been considered and studied as a major application during recent decades. In this research,heat transfer coefficient of ZnO, TiO2 and ZnO/TiO2 nanofluids in a shell and tube heat exchanger has beenstudied experimentally. ZnO nanoparticle was synthesized through pre...

The single-phase flow and thermal performance of a double pipe heat exchanger are examined by experimental methods. The working fluid is water at atmospheric pressure. Temperature measurements at the inlet and outlet of the two streams and also at an intermediate point half way between the inlet and outlet is made, using copper-constantan thermocouple wires. Mass flow rates for each stream are ...

This paper presents the heat transfer coefficients and the pressure drop measured during HC-600a (Isobutane) condensation inside a brazed plate heat exchanger: the effects of saturation temperature, refrigerant mass flux and vapour super-heating are investigated. The heat transfer coefficients show weak sensitivity to saturation temperature and great sensitivity to refrigerant mass flux. At low...