[1] A high resolution active source dataset recorded across the Southern Alps of New Zealand displays unusually strong S-wave phases, which show minimal shear wave splitting. A suite of methods was used to analyse the data to minimize the uncertainty in the anisotropy measurements. We use the Silver and Chan [1991] method, cross correlation of stacked data, and deconvolution in combination with...

Abstract In this contribution a brief overview of the development of an orthotropic material model for the simulation of clear spruce wood under simultaneous biaxial in-plane stresses and transverse shear stresses is given. The model considers an initially linear elastic domain as well as hardening and softening behaviour at higher states of stress and strain, respectively. Combining the advant...

In this contribution a brief overview of the development of an orthotropic material model for the simulation of spruce wood under simultaneous plane and transverse shear stresses is given. The model considers an initially linear elastic domain as well as plasticity behaviour including hardening and softening mechanisms at higher states of stress and strain, respectively. The newest feature of t...

Abstract—Punching shear failure is usually the governing failure mode of flat plate structures. Punching failure is brittle in nature which induces more vulnerability to this type of structure. In the present study, a 3D finite element model of a flat plate with low reinforcement ratio and without any transverse reinforcement has been developed. Punching shear stress and the deflection data wer...

Cilia and flagella are hairlike organelles that propel cells through fluid. The active motion of the axoneme, the motile structure inside cilia and flagella, is powered by molecular motors of the dynein family. These motors generate forces and torques that slide and bend the microtubule doublets within the axoneme. To create regular waveforms the activities of the dyneins must be coordinated. I...

The effect of yaw angle on wake characteristics behind a yawed square cylinder was examined at a Reynolds number (Re) of 3600. Velocity and vorticity fluctuations were measured using a one-dimensional hot-wire vorticity probe. It is found that the large-scale structures contribute the most to the streamwise and transverse velocity variances, as well as Reynolds shear stress, despite the reducti...

this paper presents a novel formulation and numerical solutions for adhesively bonded composite joints with non-linear (softening) adhesive behaviour. the presented approach has the capability of choosing arbitrary loadings and boundary conditions. in this model adherends are orthotropic laminates that obey classical lamination theory. the stacking sequences can be either symmetric or asymmetri...

Mathematical models, for the stress analysis of symmetric multidirectional double cantilever beam DCB specimen using classical beam theory, first and higher-order shear deformation beam theories, have been developed to determine the Mode I strain energy release rate SERR for symmetric multidirectional composites. The SERR has been calculated using the compliance approach. In the present study, ...

We have shown that leukocytes retract their pseudopods and detach from substrates after exposure to physiological fluid shear stresses ( approximately 1.5 dyn/cm(2)). In inflammation, however, pseudopod projection during spreading and firm adhesion on endothelium is observed even in microvessels with normal blood flow and fluid shear stresses. Thus, we examined mechanisms that may serve to regu...

Abstract The purpose of the experiment was to determine distribution shear stresses in measurement area a natural and modified wood sample. Previous tests conducted on typical Iosipescu specimen have shown that complex stress state exists at bottom notch. With transverse loading samples, flexure occurs normal arise from bending moment thus fibers are deformed. For investigations oriented shear,...