Abstarct In this paper, combination of channel, receiver frequency-dependent IQ imbalance and carrier frequency offset estimation under short cyclic prefix (CP) length are considered in OFDM system. An adaptive algorithm based on the set-membership filtering (SMF) algorithm is used to compensate for these impairments. In short CP length, per-tone equalization (PTEQ) structure is used to avoid i...

This paper discusses the design and development of Dynamic Voltage Restorer (DVR) controller for voltage unbalanced compensation using d-q-o transformation technique. The controller in d-q-o coordinates has better performance than conventional controllers. The controlled variables in d-q-o coordinates are then inversely transformed to the original voltages which produced reference voltages to a...

The topology and control of three-phase 4-wire DSTATCOM consisting of a operating flexibility in the DSTATCOM consisting of a operating flexibly in the voltage or current control mode. In the voltage control DSTATCOM topology includes three single-phase voltage source converters connected in parallel. The proposed DSTATCOM provides the voltage regulation of power factor correction along with ha...

The interline power flow controller (IPFC) is a concept of the FACTS controller for series compensation which can inject a voltage with controllable magnitude and phase angle among multi lines. This paper proposes a novel IPFC-Based Damping Neuro-control scheme using PSO for damping oscil‌la‌t‌i‌o‌ns in a power system to improve power system stability. The add‌i‌tion of a supplementary controll...

Active-matrix organic LED (AMOLED) is one of the most promising contenders for next-generation displays. However, the VT-shift issue in thin-film transistors (TFT) has to be addressed to enable wide deployment [1]. Voltage programming and current programming are well-known VT-shift-compensation techniques for analog driving. However, they all need more than 4 TFTs per pixel, which increases the...

ABSTRACT In this paper, we present a temperature compensation method for logarithmic CMOS image sensors. As Bandgap technique, the compensation circuit generates VPTAT1 and VPTAT2 voltages to compensate temperature variation of the sensor output signal voltage (Out-AC-Signal) which we call VCTAT1 and output reference voltage (VRef−ph) which we call VCTAT2. The proposed method is divided into th...

This paper presents the design, analysis, and simulated results of a three stage low power op-amp in a 0.25μm CMOS process technology. The op-amp overcomes the problems of cascading stages under low supply voltage by using modified active-feedback frequency compensation. This op-amp operates over a common-mode voltage (Vcm)from 0 to 0.6V, a supply voltage (Vdd) of 1.5V ±5%, a temperature range ...

© 2010 ETRI Journal, Volume 32, Number 4, August 2010 In this paper, we present a low-voltage low-dropout voltage regulator (LDO) for a system-on-chip (SoC) application which, exploiting the multiplication of the Miller effect through the use of a current amplifier, is frequency compensated up to 1-nF capacitive load. The topology and the strategy adopted to design the LDO and the related compe...

In this paper mainly presents about the DSTATCOM and control methodology of DC capacitor voltage, generally, the dc capacitor voltage is regulated using a PI controller when various control algorithms are used for load compensation. However, during load changes, there is considerable variation in dc capacitor voltage which might affect compensation. In this work, a fuzzy logic based supervisory...