The present contribution describes an application of a hybrid approach using fuzzy logic and particle swarm optimization (PSO) for optimizing the process parameters in the electric discharge machining (EDM) of AISI 316LN Stainless Steel. In this study, each experimentation was performed under different machining conditions of pulse current, pulse on-time, and pulse off-time. Machining performan...

Laser welding is an advance non-traditional and high energy beam welding technique for dissimilar material, which is being increasingly used in industries like automobile, nuclear reactors, aerospace etc. Again it is a very tough task to joining dissimilar materials due to their properties variation. In this present work two dissimilar metals such as copper and AISI 304 stainless steel are take...

This study explores the effects of ultrafast heating on AISI 304 austenitic stainless steel. The research shows that can lead to fine-grained mixed microstructures in steel, making it a potential alternative for modifying microstructure demonstrates minimum temperature 980 °C is required achieve fully recrystallized microstructure. results also suggest lower result finer grain size compared hig...

1569-190X/$ see front matter 2011 Elsevier B.V doi:10.1016/j.simpat.2011.10.009 ⇑ Corresponding author. Address: Laboratoire de M 42 27; fax: +33 (0) 4 91 16 44 81. E-mail address: [email protected] (A. Mau This paper describes investigations realised to perform simulations of shoulder milling operations on AISI 304L stainless steel using the commercial software LS-Dyna . A Lagrangian form...

Interactions amongst localized corrosion sites were investigated using multi-electrode arrays. The 5x20 array consisted of one hundred 250 μm AISI 316 stainless steel wires configured into a close packed rectangle. Experiments were conducted in 0.05 M NaCl to investigate interactions triggered by the presence of active pits. Interactions between primary pits and the adjacent electrode surface w...

Stable ductile crack growth in 3 mm thick AISI 304 stainless steel specimens has been investigated experimentally and numerically. Multi-linear Isotropic Hardening method coupled with the Von-Mises yield criterion was adopted for modeling elasto-plastic behavior of the material. Mode-I CT fracture specimens have been tested to generate experimental load-displacement-crack growth data during sta...

Laser assisted manufacturing methods, such as direct metal deposition (DMD) and laser beam welding (LBW), are promising methods because of their higher precision and greater productivity when compared to traditional manufacturing methods. Because these methods are relatively new, the mechanical properties of samples produced by laser assisted manufacturing are not well understood. In this study...

In the present review, attempts have been made to analyze the metallurgical, mechanical, and corrosion properties of commercial marine alloy duplex stainless steel AISI 2205 with special reference to its weldability, machinability, and surfacing. In the first part, effects of various fusion and solid-state welding processes on joining DSS 2205 with similar and dissimilar metals are addressed. M...

Laser cutting is a complex multi-input multi-output machining process. To satisfy different requirements regarding laser cut quality it is necessary to determine optimal laser cutting conditions. This paper demonstrates the application of the grey relational analysis for optimization of different laser cut quality characteristics such as the depth of separation line, drag line separation and bu...

In machining, due to the tool vibration the forces, temperatures and stresses vary during the cutting process, so as the residual stresses over the machined surface. This variation of the residual stress has never been measured and, therefore, imposes new experimental challenges. The objective of this work is to correlate the variation of the residual stresses along the cutting path with the fr...