The synthesis of a conformal three-dimensional nanostructure based on porous anodic alumina with transversal nanopores on wires is herein presented. The resulting three-dimensional network exhibits the same nanostructure as that obtained on planar geometries, but with a macroscopic cylindrical geometry. The morphological analysis of the nanostructure revealed the effects of the initial defects ...

We report a novel synthesis of porous PbSe layers on Si substrates using anodic electrochemical treatment of PbSe/CaF2/Si(111) epitaxial structures in an electrolyte solution based on glacial acetic acid and nitric acid. Electron microscopy, x-ray diffractometry, and local chemical microanalysis investigations results for the porous layers are presented. Average size of the synthesized mesopore...

A photoelectrochemical study was made to compare Zr, Ti, Zn, Sn, Fe, and Cu in 1 N sulfuric acid and/or 1 N KOH. This group includes spontaneously passive, active-passive, and nonpassive metals. The apparent direct and indirect bandgaps and the flatband potentials were measured for the anodic oxides of each metal. (The bandgaps and flat-band potentials can be used to identify the anodic oXide.)...

For the purpose of low cost and sensitive electrochemical detection of 17 beta-estradiol (E2), a multi-wall carbon nanotube (MWNT)-Nafion modified electrode was fabricated. The MWNT modified electrode shows enhancement for the anodic peak current of E2 compared with the value obtained using a bare electrode. The anodic peak current measured by square wave voltammetry after 5 min open-circuit ac...

Dye-sensitized solar cells (DSSCs) utilize high surface area metal oxide sintered particle networks to absorb molecular dyes and transport injected charge carriers. While this sintered particle architecture allows liquid electrolyte DSSCs to achieve efficiencies up to 11%, slow charge transport through the semiconductor network limits the amount of modification that can be made to the electroly...

Model calculations indicate that chaotic current oscillations during anodic electrodissolution of copper into phosphoric acid may be controlled by applying a simple map-based algorithm. In the experiments, the unstable period-one and period-two orbits embedded in the chaotic attractor have been stabilized by small perturbations of the anodic potential. We present the results of an experimental ...

We report the experimental observation of the novel phenomenon of the resistivity decrease in porous PbTe layers during the pore formation process. Investigations were performed on the n-PbTe films with 2.3-μm thickness, which were near the point of the conductivity-type inversion at room temperature. Anodic electrochemical treatment for the porous layers with 41% to 52% porosity fabrication wa...

A perm-selective nanochannel could initiate concentration polarization near the nanochannel, significantly decreasing (increasing) the ion concentration in the anodic (cathodic) end of the nanochannel. Such strong concentration polarization can be induced even at moderate buffer concentrations because of local ion depletion (therefore thicker local Debye layer) near the nanochannel. In addition...

A novel electrode modified with silver nanoparticles was fabricated. It is found that the reducibility of silver nanoparticles is higher than for bulk silver by comparing a silver nanoparticles modified electrode with a silver micro-disk electrode. When SCN was added, a new oxidation peak occurred and the anodic peak current of silver nanoparticles decreased. The new anodic peak current is prop...

nanoporous anodic aluminum oxide (aao) has been used in many different fields of science and technology, due to its great structural characteristics. solar selective surface is an important application of this type porous material. this paper investigates the effect of nanoporous aao properties, including; film thickness, pore area percentage and pore diameter, on absorption spectra in the rang...