Das Holz der Rotbuche (Fagus sylvatica L.) wird gegenwärtig nur in sehr geringem Maße für die Produktion von Brettschichtholz (BSH) verwendet. Obwohl diese Mitteleuropa am weitesten verbreitete Laubholzart ein hohes Potenzial hinsichtlich Festigkeit und Steifigkeit besitzt, wurde sie, neben dem Einsatz im Bahnbau (Schwellen), bisher überwiegend Möbelindustrie eingesetzt oder – mit geringer Wert...

The purpose of this study is to investigate bending moment and the axial load capacity of a pressurized pipe suffering from a through-wall circumferential crack repaired by a composite sleeve. The three-dimensional finite element method (FEM) was adopted to compute the results, and the failure assessment diagram (FAD) was employed to investigate the failure behavior of the repaired pipe. The fi...

In this paper, an analytical method for noncircular shape extrusion is presented. Using this method, non-linear deformation field can be described with Hermit cubic spline which is prescribed by the boundary conditions of the die at its entryand exit. The upper bound method has been used to obtain optimum coefficient of the tangential boundary conditions. The results show that the optimum tange...

In this paper, an analytical method for noncircular shape extrusion is presented. Using this method, non-linear deformation field can be described with Hermit cubic spline which is prescribed by the boundary conditions of the die at its entryand exit. The upper bound method has been used to obtain optimum coefficient of the tangential boundary conditions. The results show that the optimum tange...

rectangular waveguide (wr) is one of the earliest types of transmission lines. rectangular waveguide can be produced by hot extrusion process. in this paper, the hot extrusion process of cuzn5 rectangular waveguide was investigated by finite element method (fem). in addition, genetic algorithm method (ga) was used to optimize the die geometry and process conditions to achieve the lowest magnitu...

this research is carried out to design and manufacturing of lathe vibration tool and their tests. firstly, one-dimensional vibration tool is designed and made of the bending vibration mode. one-dimensional vibration tool with half piezoelectric rings is considered to excite the bending mode of tool. structure of vibration tool is designed in abaqus software about 20 khz and then is made with re...

The spline finite strip method (S.F.S.M.) for buckling analysis of plates and plate assemblies subjected to longitudinal compression and bending, transverse compression as well as shear is described. The method allows for the boundary conditions. Local buckling coefficients of plates with different boundary conditions under compression, bending and shear are calculated. Convergence studies with...

Springback is considered as one of the most common problems in metal forming processes, which poses an inaccuracy product angle during assembling parts. The estimation springback difficult to predict for formed parts since it depends on many factors such mechanical properties, sheet thickness, and die angle. In this work, experimental investigation drawbead different material thicknesses use lu...

Deep drawing process is one of the most applicable methods in producing industrial parts. In this process, the initial blank deforms to final product using a rigid punch and die. In this investigation, the effect of deep drawing process parameters of brass/steel laminated sheet composites on required forming force has been investigated. The process simulated using finite element method (FEM) an...