To ensure bearing reliability, it is traditional for compressor manufacturers to specify a minimum oil sump temperature difference above the saturated discharge temperature in a high-side compressor and suction temperature in a low-side compressor. This minimum oil sump temperature specification is, in essence, a surrogate measure of the minimum viscosity the compressor manufacturer reqtrires t...

It will bring about many problems for a Rl2 refrigerator compressor to use Rl34a as refrigerant directly, such as power increasing, capacity dropping, and noise rising up etc. In order to solve these problems, the mathematical model, optimization model and special test system were built up, many improvements were made by means of the calculating and the testing results. Finally, the performance...

The performance of air conditioner and the reliability of compressor could be reduced, if the refrigerant gas is discharged from compressor with excessive lubricating oil. Thus, the study of the reduction of the oil circulation rate in the compressor is required to resolve the problem. In this paper, five feasible approaches to decrease the oil circulation rate were confirmed by experiment. the...

The scroll wraps of a scroll compressor play a very important role in the compressor’s efficiency due to their impact on leakage and leakage irreversibilities. In this work, a short summary of the scroll compressor geometry is presented. Using the geometry of the scroll wraps, an optimal scroll wrap geometry is derived for a given set of constraints on compressor displacement, scroll wrap thick...

The 3D pyramid compressor project at the University of Glasgow has developed a compressor for images obtained from CLSM device. The proposed method using a combination of image pyramid coder and vector quantization techniques has good performance at compressing confocal volume image data. An experiment was conducted on several kinds of CLSM data using the presented compressor compared to other ...

A number of compressor design modifications to reduce the noise which are based on the modal characteristics of the compressor shell are discussed and special problems are pointed out. Most design changes exhibit effects across broad frequency regions and while reducing the noise in some frequency bands can cause noise increases in other bands. Shell damping was found to be a generally consiste...

The air conditioning and refrigeration systems noise consideration is continuously growing, implying more and more compressor noise measurements [1], even in-situ [2][3]. This article will introduce a new validated finite-element method to obtain the compressor noise from vibration measurements from standard test rig or directly in the field. We will describe the methodology; the devices & tool...

The energy regulation on the refrigeratory compressor is described. Both the energy-saving principle and performance of conversion compressor are discussed in detail. Two different modes of the control for compressor, frequency conversion cooling and full-frequency run, are compared here. It is concluded that frequency conversion is better than full-frequency on energy-saving. The energy saving...

For a given linear compressor, the geometric configuration of the PTR (pulse tube refrigerator) affects the dynamic behavior of the linear compressor as well as the cooling performance of the PTR. The geometric configuration of each component precisely determines the flow impedance which contains the flow resistance, the inertance effect, and the compliance effect. In this paper, several simula...

A novel method for combining active surge control system (ASCS) and surge avoidance system (SAS) for a centrifugal compressor is presented. ASCS is a promising method to improve compressor operating area by stabilizing surge. However, this method is not applied yet in industrial compressors. Safety issue is considered in implementing the ASCS. A failure in ASCS may endanger the compressor by en...