Aim of this project is the development of a new heat pump system with economizing that is able to improve the heating performance using two or more heat sources at different temperature levels. These heat sources are incorporated into the system with minimal loss of exergy by adding the heat at different pressure levels. Practical applications for such systems are for example buildings with a h...

Distillation is a method of separating chemicals based on differences in the speed or ease evaporation (volatility) material distillation, mixture substances boiled so that it evaporates, and this vapor then cooled back into form liquid. The condenser heat exchanger functions as medium for condensation process. Cooling towers are able to lower water temperature more than equipment only uses air...

As carbon dioxide emissions arising from fossil energy consumption and fuels are gradually increased, it is important for the low-carbon operation of ships to recover diesel engine waste heat. A newly developed dual-loop organic Rankine cycle (ORC) system heat a marine main (M/E) was designed in this paper. The exhaust gas (EG) recovered by high-temperature (HT) loop. jacket cooling water (JCW)...

This work presents an energy, exergy, and environmental evaluation of a novel compound PV/T (photovoltaic thermal) waste heat driven ejector-heat pump system for simultaneous data center cooling recovery district heating networks. The uses with evaporative-condenser as driving force ejector while exploiting the generated electric power to operate compressor pumps. vapor compression assessed sev...

reaction constants and heat release during thermophilic aerobic digestion of typical secondary and mixed sludges were determined. maximum reaction constant, determined by measuring the amounts of biodegradable volatile suspended solids (bvss) removed, occurred in the temperature range of 55-60 ºc. measurement of heat releases were carried out, at the same range, by the aid of a temperature prog...

An experimental investigation of the performance of thermosyphons charged with water as well as the dielectric heat transfer liquids FC-84, FC-77 and FC-3283 has been carried out. The copper thermosyphon was 200 mm long with an inner diameter of 6 mm, which can be considered quite small compared with the vast majority of thermosyphons reported in the open literature. The evaporator length was 4...

Conceptual design of a waste heat recovery cycle is carried out in attempt to enhance the thermal efficiency of a steam power plant. In the recovery system, super-critical an CO2 is employed as the working fluid operating in a Brayton cycle. Low grade heat rejected by the flue gases through the stack is used as the primary heat source, while a secondary heat exchanger utilizes th...

This paper presents a new analysis of the effects of ambient temperature variations on the surge characteristics of turbo heat pumps. To this end, an analytical model capable of predicting unsteady behavior of surge in turbo heat pumps has been developed. In compression systems, surge is mostly caused by the compressor work exceeding the mechanical inertia of the system. In refrigeration system...

Loop heat pipes (LHPs) are used in many branches of industry, mainly for cooling of electrical elements and systems. The loop heat pipe is a vapour-liquid phase-change device that transfers heat from evaporator to condenser. One of the most important parts of the LHP is the porous wick structure. The wick structure provides capillary force to circulate the working fluid. To achieve good thermal...

1. Steam Generation 1.1. General Characteristics 1.2. Circulation in Boiling Water Reactors 1.3. Steam Generation in CANDU Reactors 1.4. Steam Generators 1.5. Steam Generator for PWR and CANDU Systems 1.6. Heat Transfer 2. Steam Generator Operation 2.1. Swelling and Shrinking 2.1.1. Steady State Swelling and Shrinking 2.1.2. Transient Swelling and Shrinking 2.2. Level Control 2.3. Carryover 2.4...