In this paper we have shown that electrode polarization impedance (EPI) can be separated from measured tissue impedance as long as the characteristic frequencies of EPI and tissue are not too close, so that the EPI is largely displayed as a separate dispersion. In 2-electrode measurements the EPI and sample are physically connected in series, and commonly modelled by equivalent components in se...

− The paper presents a new method of anticorrosion coatings diagnostics using bilinear transformation. It is possible to identify the parameters of the equivalent circuit of the coating on the basis of object impedance measurement at a few, optimally selected measurement frequencies. The rules of optimal frequency selection are given. The number of frequencies is equal to the number of the equi...

The system shown in Figure 1 is a linear model of the Quanser SRV-02 DC motor with a static inertial load. In the model, • Rs is the resistance of the cable leading to the motor. Realistically, it should also include the output impedance of the amplifier driving the cable. Because the motor is a part of the process being controlled, the amplifier and cable together make up the actuator of the p...

This paper presents simple and accurate approach to compute the minimum value of capacitance required for initiating the voltage build-up in a three-phase selfexcited induction generator. Based on the steady-state equivalent circuit model different numerical methods for solving frequency are known from previous literature, which are of 6 th order polynomial. In this paper the order of the polyn...

The system shown in Figure 1 is a linear model of the Quanser SRV-02 DC motor with a static inertial load. In the model, • Rs is the resistance of the cable leading to the motor. Realistically, it should also include the output impedance of the amplifier driving the cable. Because the motor is a part of the process being controlled, the amplifier and cable together make up the actuator of the p...

This paper proposes an efficient approach for the computation of voltage stability margin (VSM) in a large-scale power grid. The objective is to accurately and rapidly determine the load power margin which corresponds to voltage collapse phenomena. The proposed approach is based on the impedance match-based technique and the model-based technique. It combines the Thevenin equivalent (TE) networ...

Impedance-based stability analysis normally splits an interconnected system into source and load subsystems and the stability of the closed loop system can be analyzed by the combined input-output gains of source and load. This is an intuitive approach in the case of Single-Input Single-Output (SISO) systems. However, in the case of grid-tied voltage source converter (VSC) systems, dq impedance...

In this study, effect of immersion time on the electrochemical behaviour of AISI 321 stainless steel (AISI 321) in 0.1 M H 2SO 4 solution under open circuit potential (OCP) conditions was evaluated by potentiodynamic polarization, Mott–Schottky analysis and electrochemical impedance spectroscopy (EIS). Mott–Schottky analysis revealed that the passive films behave as n-type and p-type s...

This paper is about the implementation of SEPIC Converter and Induction Motor fed water pumpanalysis to improve the efficiency of the input and it act as a impedance matching network. SEPIC Converter is a newly invented chopper in which it has less no components. So, switches losses and conduction losses are reduced in turn it improves the efficiency and reduce the harmonics. When internal impe...

We review some of the recent advances in the simulation of plasmonic devices, drawing examples from our own work in metal-insulator-metal (MIM) plasmonic waveguide components and networks. We introduce the mode-matching technique for modeling of MIM waveguide devices. We derive the complete set of orthogonal modes that the MIM waveguide supports and use it to apply the mode-matching technique t...