MnZnFe2O4 ferrite nanoparticles were prepared by co-precipitation method using a microwave heating system at temperature of 100 C. X-ray diffraction reveals the samples as prepared are pure ferrite nanocrystalline phase, transmission electron microscopy image analysis shows particles are in agglomeration state with an average size of about 10 nm, furthermore, crystal size of samples are increas...

A metallic coupler is proposed to interface a silicon on insulator (SOI) waveguide with a narrow hybrid plasmonic waveguide (200× 200 nm). The device operation is investigated and optimized to attain the best tradeoff between the mode confinement and the propagation loss. Calculations reveal that a high confinement and low loss of the energy is achieved from a silicon slab waveguide into the di...

the microstructure of dual phase steels can be considered as a matrix of ferrite phase reinforced by martensite particles. recent measurements show that the mechanical properties of the ferrite phase are changed with the distance from the martensite grains. in this paper, a new method has been proposed to consider this phenomenon in finite element modeling of dual phase steels microstructure. i...

Rectangular waveguide is one of the earliest types of transmission lines. Rectangular waveguide can be produced by hot extrusion process. In this paper, the hot extrusion process of CuZn5 rectangular waveguide was investigated by Finite Element Method (FEM). In addition, Genetic Algorithm (GA) was used to optimize the die geometry and process conditions to achieve the lowest magnitude of extrus...

The decomposition of austenite to ferrite or cementite begins at the equilibrium phase boundary of austenite/ (ferrite austenite) or austenite/(cementite austenite) in binary Fe–C phase diagram. The temperature values on the phase boundaries of austenite/(ferrite austenite) and austenite/(cementite austenite) at a certain carbon content are called Ae3 and Acm temperatures of the steel, respecti...

INTRODUCTION Stainless steel welds characteristically consist of a two-phase austenite plus ferrite microstructure. Ferrite levels may vary from a few percent in austenitic stainless steel welds to more than 50% in duplex stainless steel welds. The ability to predict the ferrite content in these welds is essential for many reasons. To a large extent, the final ferrite content determines a weldm...