LLE Review, Volume 101 23 Introduction The importance of conducting a quantitative, high-spatialresolution investigation of thin-film-damage morphology is twofold. First, comparison of spatial frequencies of the damaged site with the surrounding unmodified material may indicate the presence of particular processes in the damage event. For instance, a smooth surface that is missing granular film...

ZnO thin films deposited on various substrates were characterized by slow positron implantation spectroscopy (SPIS) combined with X-ray diffraction (XRD). All films studied exhibit wurtzite structure and crystallite size 20-100 nm. The mosaic spread of crystallites is relatively small for the films grown on single crystalline substrates while it is substantial for the film grown on amorphous su...

objective: radiochromic ebt3 film is a later generation of radiochromic films. the aim of this study is to compare ebt and ebt3 radiochromic films in radiotherapy fields of breast cancer. methods: a rando phantom was irradiated by a 6 mv siemens primus linac with medial and lateral fields of radiotherapy of breast cancer. dosimetry was performed in various points in the fields using ebt and ebt...

The growth of GaAs thin films on Molybdenum foils was investigated in an attempt to find a low-cost substrate for GaAs. The films were grown by metalorganic chemical vapor deposition (MOCVD). The film thickness was in the 2–4μm range, while the deposition temperature was in the 650o-825°C range. Scanning electron microscopy (SEM) and transmission electron microscopy (TEM) were used to investiga...

Microstructural features of sputtered chromium and chromium-50 wt. % platinum thin films on carbon substrates are presented. Films produced by rf sputtering and dc magnetron sputtering are compared using analytical electron microscopy techniques. All rf-sputtered films are uniform in chemistry and thickness and are amorphous. The chromium film became crystalline with a grain size ofless than 10...

Two buckling modes have been observed in thin films: buckle delamination and wrinkling. This letter identifies the conditions for selecting the favored buckling modes for elastic films on elastic substrates. Transition from one buckling mode to another is predicted as the stiffness ratio between the substrate and the film or is predicted for variation of the stiffness ratio between the substrat...

A kind of resistance-type multi-wall carbon nanotubes (MWNTs) film sensor was fabricated using layer-by-layer self-assembly, and an astable multivibrator circuit was designed for resistance measurement. The electrical properties of MWNTs film sensor were investigated, and also its ethanol gassensing properties with varying gas concentration are characterized at room temperature. The experiment ...

In the last decade, lead zirconate titanate oxide (PZT) thin-film actuators have received increasing attention because of their high frequency bandwidth, large actuation strength, fast response, and small size. The PZT film thickness is usually less than several microns as opposed to hundreds of microns for bulk PZT patches that are commercially available. As a result, PZT thin-film actuators p...

ZnO thin films deposited on various substrates were characterized by slow positron implantation spectroscopy (SPIS) combined with X-ray diffraction (XRD). All films studied exhibit wurtzite structure and crystallite size 20-100 nm. The mosaic spread of crystallites is relatively small for the films grown on single crystalline substrates while it is substantial for the film grown on amorphous su...