In this study, the influence air fuel ratio and injection timing on the engine performance of 4-cylinder direct injection hydrogen fueled engine was investigated. The effect of air fuel ratio (AFR) and engine speed on optimum injection timing is presented. The 4-cylinder direct injection hydrogen engine model was developed utilizing the GTPower commercial software. This model employed one dimen...

This paper provides a comparison of techniques used to model the fuel flow to shaft speed relationship of a Spey gas turbine engine. Linear models are examined and the need for nonlinear modelling is justified. A technique based on nonparametric data analysis is proposed, to simplify the identification of a nonlinear model of the engine. A NARMAX model is identified and its performance validate...

In this work second order linear model, reduced order (first order) linear model and second order nonlinear model of a gas turbine engine have been obtained from the engine input-output data using evolutionary optimization technique. These three models have then been used in local optimal control design. The obtained controllers have been applied to the second order non-linear engine model and ...

To properly simulate the highly anisotropic turbulent engine flows, higher order turbulence model should be used to correctly reproduce flow physics inside the engine. The popular KIVA computer code has been modified to include the Reynolds-stress turbulence model (RSTM) for this purpose. The objective of this paper is to present our recent research on the use of RSTM and the KIVA code for engi...

The aeroderivate gas turbines are widely used for power generation in the oil and gas industry. In offshore marine platforms, the aeroderivative gas turbines provide the energy required to drive mechanically compressors, pumps and electric generators. Therefore, the study of the performance of aeroderivate gas turbines based on a parametric analysis is relevant to carry out a diagnostic of the ...

For numerical prediction of the NOX in the exhaust of a compression ignition engine a model was developed by considering the parameter equivalence ratio. This model was validated by comparing the predicted results of NOX with experimental ones. The ultimate aim of the work was to access the applicability, robustness and performance of the improved NOX model against other NOX models. Keywords—Bi...

It is a well known fact that, dual fuel engines at part loads, inevitably suffer lower thermal efficiency, higher carbon monoxide and unburned fuel emission. The work in this paper is to investigate combustion characteristics of a dual fuel (diesel-gas) engine at part loads, using a single zone combustion model with detailed chemical kinetics for combustion of natural gas fuel. The authors deve...

Landfill gas (LFG) that is generated in an anaerobic environment in landfills and consists primarily of methane and carbondioxide with small amount of nitrogen and other non-methane gases, could be collected and used to produce energy either by extracting methane or using the landfill gas directly in an internal combustion engine or a gas turbine. It amounts to be a net-negative greenhouse gas ...

Due to stricter emission legislation, there is a need for more efficient control of diesel engines with exhaust gas recirculation(EGR). In particular, it is important to estimate the air/fuel ratio accurately in transients. Therefore a new engine gas flow model has been developed. This model divides the gas into one part for oxygen and one part for inert gases. Based on this model an observer h...