Resistance to xylem cavitation depends on the size of xylem pit membrane pores and the strength of vessels to resist collapse or, in the case of freezing-induced cavitation, conduit diameter. Altering these traits may impact plant biomechanics or water transport efficiency. The evergreen sclerophyllous shrub species, collectively referred to as chaparral, which dominate much of the mediterranea...

Previous studies of the hydraulic conductivity of connective tissues have failed to show a correspondence between ultrastructure and specific hydraulic conductivity. We used the technique of quick-freeze/deep-etch to examine the ultrastructure of the corneal stroma and then utilized morphometric studies to compute the specific hydraulic conductivity of the corneal stroma. Our studies demonstrat...

The surface finish between two mating parts in an assembly has significant influence on the mechanical properties such as wear resistance, corrosion resistance, fatigue resistance and stress concentration. The choice of surface finishing operation such as honing and lapping is based on functional requirements of an assembly. As these processes are expensive, the design engineer should be cautio...

Main resistances of the plant water transport system are situated in leaves. In contrast to angiosperm leaves, knowledge of conifer needle hydraulics and of the partitioning of resistances within needles is poor. A new technique was developed which enabled flow-meter measurements through needles embedded in paraffin and thus quantification of the specific hydraulic conductivity (K(s)) of the ne...

Xylem traits were examined among 22 arid-land shrub species, including measures of vessel dimensions and pit area. These structural measures were compared with the xylem functional traits of transport efficiency and safety from cavitation. The influence of evolution on trait relationships was examined using phylogenetic independent contrasts (PICs). A trade-off between xylem safety and efficien...

Water transport in conifers occurs through single-celled tracheids that are connected to one another via intertracheid pit membranes. These membranes have two components: the porous margo, which allows water to pass through the membrane, and the impermeable torus, which functions to isolate gas-filled tracheids. During drought, tracheids can become air filled and thus hydraulically dysfunctiona...

A linear piston hydraulic angular-velocity-based control knee joint was designed for people with knee-extensor weakness to engage knee-flexion resistance when knee-flexion angular velocity reaches a preset threshold, such as during a stumble, but to otherwise allow free knee motion. During mechanical testing at the lowest angular-velocity threshold, the device engaged within 2 degrees knee flex...

We tested the hypothesis that greater cavitation resistance correlates with less total inter-vessel pit area per vessel (the pit area hypothesis) and evaluated a trade-off between cavitation safety and transport efficiency. Fourteen species of diverse growth form (vine, ring- and diffuse-porous tree, shrub) and family affinity were added to published data predominately from the Rosaceae (29 spe...

A hydraulic fluid impedance plot is produced by plotting instantaneous differential pressure against phasic blood flow across a vascular segment. This simple plot quantitatively and compactly describes the changes in flow resistance (impedance) throughout the entire cardiac cycle. Impedance plots were obtained before and after corrective surgery in patients with a variety of left ventricular ou...