In the present analysis an unsteady laminar forced convection water boundary layer flow is considered. The fluid properties such as viscosity and Prandtl number are taken as variables such that those are inversely proportional to temperature. By using quasi-linearization technique the nonlinear coupled partial differential equations are linearized and the numerical solutions are obtained by usi...

A nonsimilarity analysis is performed to investigate the laminar, free convection boundary layer flow over a permeable isothermal truncated cone in the presence of a transverse magnetic field effect. A suitable set of dimensionless variables is used and non-similar equations governing the problem are obtained. Fourth order Runge-Kutta with shooting technique is employed for the numerical soluti...

Numerical simulation of the steady, laminar, forced convection heat transfer in the finned annulus is carried out for the case of fully developed incompressible flow corresponding to thermal boundary condition of uniform heat input per unit axial length with peripherally uniform temperature at any cross section. Boundary fitted curvilinear coordinates are used to overcome the singularities, bei...

using of nanofluids and ducts with corrugated walls are both supposed to enhance heat transfer, by increasing the heat transfer fluid conductivity and the heat transfer area respectively. use of a diverging duct with a jet at inlet section may further increase heat transfer by creating recirculation zones inside the duct. in this work two-dimensional incompressible laminar flow of a nanofluid e...

The aqueous thermal boundary layer near to the ocean surface, or skin layer, has thickness O(1 mm) and plays an important role in controlling the exchange of heat between the atmosphere and the ocean. Theoretical arguments and experimental measurements are used to investigate the dynamics of the skin layer under the influence of an upwelling flow, which is imposed in addition to free convection...

Thermosolutal convection in a square cavity filled with air and submitted to an inclined magnetic field is investigated numerically. The cavity is heated and cooled along the active walls with a mass gradient whereas the two other walls of the cavity are adiabatic and insulated. Entropy generation due to heat and mass transfer, fluid friction and magnetic effect has been determined in transient...

The indoor airflow with a mixed natural/forced convection was numerically calculated using the laminar and turbulent approach. The Boussinesq approximation was considered for a simplification of the mathematical model and calculations. The results obtained, such as mean velocity fields, were successfully compared with experimental PIV flow visualizations. The effect of the distance between the ...

fluids for various industrial applications because of their excellent thermal performance. this study analytically and experimentally examines the effects of nanoparticle dispersion on the entropy generation of eg–al2o3 nanofluid flows through a helical pipe as a heat exchanger under constant wall heat flux thermal boundary condition in laminar regime. it is found that adding nanoparticles impr...

the paper numerically presents laminar forced convection of a nanofluid flowing in a duct at microscale. results were compared with both analytical and experimental data and observed good concordance with previous studies available in the literature. influences of brinkman and reynolds number on thermal and hydrodynamic indexes have been investigated. for a given nanofluid, no change in efficie...

The entropy generation due to steady laminar forced convection fluid flow through parallel plates microchannel is investigated numerically. The effect of Knudsen, Reynolds, Prandtl, Eckert numbers and the nondimensional temperature difference on entropy generation within the microchannel is discussed. The fraction of the entropy generation due to heat transfer to the total entropy generation wi...