The Air conditioning system satisfies the various space conditions required for the comfort and industrial air conditioning. Now days demand for AC system applications are increasing and include the areas of application like apartment buildings, banks, office buildings, industrial plants, schools, restaurants etc. This growing demand for air conditioning system forced manufactures to develop su...

This paper presents the results of a statistically designed experiment with eight all-refrigerator cabinets. The cabinets were designed with a view to be identical except for the fact that each cabinet was fitted with a specific non-adiabatic capillary arrangement. These cabinets were tested to the New Zealand test standard (NZS 6205.2) at 32°C ambient temperature and then the tests were repeat...

As a natural refrigerant, CO2 gets more and more attention in recent years. The CO2 system runs at a trans-critical cycle. This leads to a high running pressure and high pressure difference for the CO2 compressor. In this paper the single stage and two stage rolling piston compressors with same displacement have been developed for CO2 heat pump water heater. And a comprehensive performance comp...

Kim, Woohyun. Ph.D., Purdue University, December 2013. Fault Detection and Diagnosis for Air Conditioners and Heat Pumps based on Virtual Sensors. Major Professor: James E. Braun, School of Mechanical Engineering. The primary goal of this research is to develop and demonstrate an integrated, on-line performance monitoring and diagnostic system with low cost sensors for air conditioning and heat...

Selection of spiral capillary tube for refrigeration appliances and the effect of changes in the parameters such as capillary tube dimensions i.e. capillary tube diameter, coil pitch, capillary tube length and inlet conditions of refrigerant to the capillary tube i.e. degree of subcooling, inlet pressure on the mass flow rate of the refrigerant, also investigation about the coiling effect of sp...

Air-cooled cross flow heat exchangers are very popular in the refrigeration and air conditioning industry. The fin type, tube arrangement, flow circuitry, and many geometry parameters, are to be designed and optimized. In this paper, a generic simulation and optimization tool for the design of air-cooled condensers/evaporators is introduced. It is featured with a user-friendly interface, freedo...

The compressor motor of an air conditioner is subjected to the a fluctuating load torque during suction and discharge refrigerant, resulting in speed ripple machine angular cycle. This paper proposes new predictive feedforward control system that predicts suppresses cuased by periodic disturbance using error data PI controller. suppression performance proposed method experimentally confirmed ap...

The exergetic analysis is a tool that has been used successfully in many studies aiming a more rational energy consumption to reduce the cost of processes. With this analysis, it is possible to perform an evaluation of the overall process, locating and quantifying the degradation of exergy. This paper applies exergy approach for analyzing the heat exchanger network design and refrigeration of M...

This work presents an experimental approach to study the refrigerant flow through capillary tube-suction line heat exchangers. Lateral heat exchanger performance with refrigerant HFC-134a was experimentally evaluated for a range of heat exchanger assemblies and operating conditions typically found in household refrigerators and freezers. Based on the resulting performance data base, the influen...

Models for unitary air conditioners and heat pumps typically have difficulties in providing accurate predictions for the following situations: 1) charge modeling over a large range of charge levels, 2) two-phase refrigerant entering fixed-orifice expansion devices, 3) two-phase refrigerant entering compressors, and 4) non-uniform refrigerant mass flow allocation among evaporator circuits at low...