The present study evaluates the effects of occlusal loading on an implant-supported dental implant with external hexagon implant-abutment systems, using finite element method analysis. Tensile analyses were performed to simulate different axial and obliquous masticatory loads. influence variations in contouring conditions interfaces was analyzed weigh osseointegration linear non-linear cases, b...

The technique of estimating the complex frequency components a signal in presence noise based on assumptions about number is known as estimation. problem estimation appears when we receive from transmitter with frequency, and it often radar, sonar, etc. applications. This has been dealt by various techniques algorithms. research shows methods used researchers to estimate paper discusses between...

Abstract The aim of this work is to study the stress distributions and location hot spots in vicinity intersection lines tubular elements TY-joints. Using finite element models, we analyze effects geometrical parameters on concentration factor case in-plane bending out-of-plane loads, around weld toe joints. Our results reveal maximum at heel or loads saddle point loads. Six parametric equation...

Presented is a total-Lagrangian displacement-based non-linear finite-element model of thin-film membranes for static and dynamic large-displacement analyses. The membrane theory fully accounts for geometric non-linearities. Fully non-linear static analysis followed by linear modal analysis is performed for an inflated circular cylindrical Kapton membrane tube under different pressures, and for ...

conclusions this study indicates that low-load rt results in greater accumulations in vl compared to high-load rt over the course of 8 weeks of training. results after adjusting for the pre-test scores, there was a significant difference between the two intervention groups on post-intervention total vl with a very large effect size (f (1, 15) = 16.598, p = .001, ηp2 = .525). there was a signifi...

The unbalanced current drawn by the composite loads in small-scale industries is mainly due to single-phase loads. Any operation of will cause unbalance and produce distortion non-linear neutral increased voltage at load end reduced an increase linear Industries find it difficult balance control current. To overcome problem, this work aims add a passive network different configurations along wi...

Ac to DC converter is used for operating DC electrical machine and also supplies DC power to battery which is used for many purposes. The main purpose of this project is to compensate the harmonics by using harmonic current compensation and reactive power control. If reactive power is compensate prior to system then non linearity or harmonics present in the system does not much affect the exist...