The U.S. National Institute for Occupational Safety and Health (NIOSH) is conducting mine illumination research to determine if light-emitting diode (LED) cap lamps can improve safety by reducing glare. Glare can impede a miner’s ability to see hazards and to safely perform their work.Another objective is to determine if a person’s age is a factor.This is important because the workforce is agin...

The Shuttle Solar Backscatter Ultraviolet (SSBUV) programme uses 1000 W, quartz-halogen, tungsten coiled ® lament (FEL) lamps as the primary radiometric calibration source in the 250 nm to 405 nm wavelength region. The National Institute for Standards and Technology (NIST) recommends using the product of a ® fth-order polynomial and a Planck function as a ® tting function for interpolating the ...

OBJECTIVE To test the hypothesis that bonding with a blue light-emitting diode (LED) curing unit produces no more failures in adhesive-precoated (APC) orthodontic brackets than bonding carried out by a conventional halogen lamp. MATERIALS AND METHODS Sixty-five patients were selected for this randomized clinical trial, in which a total of 1152 stainless steel APC brackets were employed. In or...

Around 66% of power plants in Indonesia are still sourced from coal and oil. On the other hand, is rich renewable energy potential but has minimal utilization. Furthermore, voltage at that small less stable also often a nuisance. Thus, an innovative hybrid, solar hydroelectric plant with PID (Proportional Integral Derivative) based stabilizer was created. PID-based control generated form PWM (P...

Materials of steam water cycles can suffer from corrosion induced by halide anions in feedwater. Organic halogen compounds in feedwater can be degraded and release halide anions under high temperature and pressure. Therefore it is necessary to be able to measure the organic halogen concentration. Existing measurements including Adsorbable Organic Halogens and Gas Chromatography are either not c...

Bilayer Mg/Co and Mg/Mn (700nm) thin films were prepared using thermal evaporation method at pressure10 torr at room temperature. The films were rapid thermal annealed (RTA) using halogen lamp to get a homogeneous structure of thin films. The hydrogen gas was introduced in hydrogen chamber, where samples were kept at different pressure from 10 to 40 psi of H2 for thirty minutes. The conductivit...

This paper proposes a vehicle light detection method using a hyperspectral camera instead of a Charge-Coupled Device (CCD) or Complementary metal-Oxide-Semiconductor (CMOS) camera for adaptive car headlamp control. To apply Intelligent Headlight Control (IHC), the vehicle headlights need to be detected. Headlights are comprised from a variety of lighting sources, such as Light Emitting Diodes (...

We compared the learning performances of BALB/c mice subjected to the Morris water spatial task under two different lighting conditions. In the first one, the experimental room was lit by neon tubes (direct and bright illumination) and in the second one by a halogen lamp directed to the roof (diffuse illumination). The scores of BALB/c mice in the diffuse illumination condition clearly demonstr...