Scandium-reinforced aluminum alloys represent a new generation of high-performance alloys that display numerous advantages over high-strength aluminum alloys. Scandium-reinforced alloys are much stronger than other high-strength alloys, exhibit significant grain refinement, strengthen welds, and eliminate hot cracking in welds. These alloys also exhibit a good resistance to corrosion as shown b...

PURPOSE The aim of this study was to investigate the effect of reinforcing materials on the fracture resistances of glass fiber mesh- and Cr-Co metal mesh-reinforced maxillary complete dentures under fatigue loading. MATERIALS AND METHODS Glass fiber mesh- and Cr-Co mesh-reinforced maxillary complete dentures were fabricated using silicone molds and acrylic resin. A control group was prepared...

In difficult soil conditions, engineers sometimes choose to combine reinforced soil and spread footings instead of deep foundations. Among the available techniques for soil reinforcement, vibro stone columns are frequently used to reduce the liquefaction risk, improve the soil properties and improve the overall seismic performance. While there are different models available to evaluate the bear...

By installing FBG sensors on the geogrids, smart geogrids can both reinforce and monitor the stability for geogrid-reinforced slopes. In this paper, a geogrid-reinforced sand slope model test is conducted in the laboratory and fiber Bragg grating (FBG) sensing technology is used to measure the strain distribution of the geogrid. Based on the model test, the performance of the reinforced soil sl...

A polycyclic fatigue damage model for short glass fibre reinforced thermoplastics is developed and implemented into ABAQUS FE code using UMAT subroutine. The MNL model is introduced here in terms of damage rates: ( ) ) ( 2 0 1 2 0 2 1 2 1 1 ) ( ) ( N ij ij ij ij ij ij ij ij ij ij ij e E E N d d λ β ε γ ε β β α − −       +       + = ∂ ∂ = & (1) Where N is the number of cycles. αij, β...

Numerical simulation based on finite element method is conducted to predict the location of pitting corrosion in reinforced concrete. Simulation results show that it is feasible to predict corrosion monitoring based on ultrasonic guided wave in reinforced concrete, and wavelet analysis can be used for the extremely weak signal of guided waves due to energy leaking into concrete. The characteris...

The use of self-tapping screws with continuous threads as a reinforcement to avoid splitting of members in connections with dowel-type fasteners was studied in two projects carried out at the Universities of Nottingham and Karlsruhe. The reinforced specimens showed a very ductile failure mode whereas the non-reinforced specimens failed in a brittle way. Although the reinforced specimens also sh...

Heart contractions cause periodic wavy buckling of microtubles. M uch of the mechanical strength of micro-tubules comes from the cytoskeleton surrounding them, report Brangwynne et al. on page 733. When compressive forces push on a microtubule in a cell, such as when a growing polymer butts up against the cell edge, the fi ber bends in multiple short wavelength curves like a snake. By contrast,...

this study evaluates two different types of techniques for concrete hollow-block sections reinforced with traditional steel rebars and wire meshes, and compares their structural behaviour to that of an ordinary reinforced concrete beam section. the comparisons are based on the responses both before and after they were repaired with glass fibre reinforced polymers (gfrp). the specimens were subj...

Dynamic behavior of soil are evaluated relative to a number of factors including: strain level, density, number of cycles, material type, fine content, geosynthetic inclusion, saturation, and effective stress .This paper investigate the dynamic behavior of saturated reinforced sand under cyclic stress condition. The cyclic triaxial tests are conducted on remolded specimens under various CSR whi...