in this study, a bearing capacity device is designed and fabricated to determine the load-settlement behavior of three circular footing models resting above the ground water table. capillary rise in the studied well graded sand is measured and the level of the water table is controlled at the desired heights during each bearing capacity test. moreover, shear strength parameters and soil water r...

ABSTRACT Fiber Reinforced Polymer (FRP) composite systems can be used for shear strengthening of reinforced concrete (RC) members. The present study investigated the shear performance and the modes of failure of simply supported RC T-beams externally strengthened in shear with FRP composites. Two different FRP-based strengthening systems were investigated, namely, externally bonded FRP sheets a...

Consistent with capacity design principles and requirements of ductile behavior, the 2005 AISC and 2001 CSA seismic design codes require that the intermediate horizontal boundary elements HBEs of steel plate shear walls SPSWs be designed to remain essentially elastic with the exception of plastic hinges at their ends when the infill plates fully yield under seismic loading. However, the unexpec...

Adipose-derived stem cells (ASCs) possess significant therapeutic potential for tissue engineering and regeneration. This study investigates the endothelial differentiation and functional capacity of ASCs isolated from elderly patients. Isolation of ASCs from 53 patients (50-89 years) revealed that advanced age or comorbidity did not negatively impact stem cell harvest; rather, higher numbers w...

Tests on eighteen small scale models which simulate the elastic and post-buckling behaviour of plate girders when subjected to shear loading are reported and discussed. Themodels were fabricated of steel and Araldite; the major aim was to assess whether small scale models can be employed to study shear buckling problems. A secondary object was to examine whether araldite could be used for predi...

This study presents the shear performance and the modes of failure of reinforced concrete (RC) beams strengthened with externally bonded carbon fiber reinforced polymer (CFRP) wraps. The experimental program consisted of testing twenty-seven, full-scale, RC beams. The variables investigated in this research study included steel stirrups (i.e., beams with and without steel stirrups), shear span-...

The steel frame reinforced with steel shear wall is a lateral load resisting system and has higher strength and shear performance than the concrete shear wall system. Especially, using corrugated steel plates in these shear wall systems improves out-of-plane stiffness and flexibility in the deformation along the corrugation. In this paper, a cyclic loading test of this steel frame reinforced wi...

This paper presents investigation carried out, including experimental and numerical studies, on low-rise shear-dominated brick masonry structures for the calculation of force reduction factor R. Basic experimental tests were conducted on masonry constituent materials for mechancial characterization. In-plane quasi-static cyclic tests were conducted on twelve full scale brick masonry walls, to u...

This paper presents two shear tests of -in. diameter cast-in anchors embedded in the plastic hinge zone of reinforced concrete columns. Design codes, such as ACI 318-14, require special reinforcement for concrete anchors in concrete that could be substantially damaged during an earthquake. The test anchors in this study were equipped with the anchor reinforcement recommended and verified in the...

Problem statement: The presence of vegetation increases the soil burden stability along slopes and reduces soil erosion. Its contribution is due to mechanical (reinforcing soil shear resistance) and hydrologic controls on streambank and superficial landslides. This study presented the results carried out from experimental in situ test focused to study the increased shear resistance of soil bloc...