The authors have re-examined the Strength-Life Equal Rank Assumption (SLERA) that is used in the fatigue life prediction of composite materials, and suggest that this assumption may be valid for a wide range of fibre-reinforced epoxy laminates subjected to tensile, compressive or shear fatigue Ioadings. The evidence presented here suggests that there may be an exact correlation between the init...

Titanium alloy TC1 and Aluminum alloy LF6 were butt jointed and lap jointed by friction stir welding (FSW), and the influence of process parameters on formation of weld surface, cross-section morphology and strength were studied. The results show that, Titanium and Aluminum dissimilar alloy is difficult to be butt joined by FSW, and some defects such as cracks and grooves are easy to occur. Whe...

Mechanical properties of electrorheological uids under various dynamical loading conditions have been studied using a computer simulation model. The model assumes electrostatic point-dipole interaction between particles with or without multipolar corrections and the interaction with the base uid due to viscous laminar ow is described with Stokes drag. The mechanical loading is introduced as con...

Push-out and pull-out tests are used for destructive evaluation of implant-bone interface strength. Because nondestructive mechanical tests would allow maintenance of an intact interface for subsequent morphological study, we developed such a test to determine the shear modulus of the interface by measuring the shear deformation of a thin layer adjacent to the implant. A polyurethane foam model...

In 3-D analyses of rock slopes there’re can be numerous sliding paths a long a coplanar nonpersistent discontinuity with a known strike. This paper describes an approach for the determination of a most probable sliding path. For this particular study, several blocks of gypsum with the dimensions of 15×15×15 cm containing coplanar non-persistent open joints were fabricated. The models have vario...

Odontoid process fracture accounts for 5% to 15% of all cervical spine injuries, and the rate is higher among elderly people. The anterior cannulated screw fixation has been widely used in odontoid process fracture, but the fixation strength may still be limited under some circumstances. This study aims to investigate the biomechanical fixation strength of expansive double-threaded bi-direction...

Biomass tensile and shear ultimate failure stresses were measured with the aim of identifying biomass ‘‘weakest mode of failure’’ or ‘‘natural fracture point’’ as a basis for future grinder designs. Switchgrass (Panicum virgatum L.) ultimate stresses were determined for Alamo and Kanlow varieties over ranges in maturity and moisture content. Alamo had greater ultimate tensile stress than Kanlow...

Probabilistic edge-delamination strength of a thermosetting polymer composite was studied experimentally in this work. During the procedure, by means of edge-delamination tensile test, the graphite–fiber/epoxy laminate made of unidirectional Toray P7051S-20Q-1000 prepregs with an optimized lay-up of [122/–122/02]S was used for examining its probabilistic distributions of the edge-delamination o...