To obtain satisfactory welds in positional laser beam welding, it is necessary to know how process parameters will influence the quality of welds in different welding positions. In this study, the titanium alloy Ti6Al4V sheets were laser welded in two vertical welding positions (vertical up and vertical down), and the appearance, porosity, strength, and ductility of the laser joints were evalua...

This article proposes a novel method for analyzing residual stress and deformation in butt welding on 6 mm SUS304 stainless steel plates, using MSC.MARC, a commercial finite element method software, to find the best location for jig fixtures that will minimize welding deformation. Simulation and experimental studies show that a distance of 100 mm between the jig center and the welding bead cent...

Two laser transmission welding experiments involving polyvinyl chloride are presented that aim to validate a previously presented welding model while helping to further understand the relationship between welding parameters and weld quality. While numerous previous research papers have presented the results of laser welding experiments, there exists minimal work validating models of the welding...

Since welding residual stress is a major factor in the generation of Primary Water Stress Corrosion Cracking (PWSCC), it is essential to examine the welding residual stress to prevent PWSCC. In order to predict this residual stress, several artificial intelligence methods have been developed and used as a powerful tool in nuclear engineering fields. In this study, two data-based models, support...

This investigation aims to explore determinants of exposure to particle size-specific welding fume. Area sampling of ultrafine particles (UFP) was performed at 33 worksites in parallel with the collection of respirable particles. Personal sampling of respirable and inhalable particles was carried out in the breathing zone of 241 welders. Median mass concentrations were 2.48 mg m(-3) for inhalab...

To address control difficulties in laser welding, we propose the idea of a self-learning and self-improving laser welding system that combines three modern machine learning techniques. We first show the ability of a deep neural network to extract meaningful, low-dimensional features from high-dimensional laser-welding camera data. These features are then used by a temporal-difference learning a...

Shrink-fitting, a common bonding technique in metal assemblies, was used for mortise and tenon wood joints. The joints had considerable strength. Shrink-fitting yielded joint strengths comparable to those obtained by using several welded dowels. Increasing the number of welded dowels, however, produced joints of higher strength than those bonded just by shrink-fitting. Combining in the same joi...

PURPOSE Welders are exposed to airborne particles from the welding environment and often develop symptoms work-related from the airways. A large fraction of the particles from welding are in the nano-size range. In this study we investigate if the welders' airways are affected by exposure to particles derived from gas metal arc welding in mild steel in levels corresponding to a normal welding d...

this paper presents a new arc starter circuit that is usable in manual metal arc welding (mma) power supplies. the proposed circuit uses an auxiliary circuit and a series coupling transformer for adding high frequency spikes to output dc voltage during arc striking. the proposed circuit is usable in inverter based arc welding supplies and it could result in a decrease of weigh, volume and expen...

INTRODUCTION: Electric arc welding and oxy-fuel gas welding are the commonest welding technologies used in small scale industries in Nigeria. Electric arc welders are exposed to serious health hazards like exposure to welding smoke. Health effects of such exposure include metal fume fever, and increased risk of chronic diseases and cancers. Exposure to welding smoke can be minimized by use of P...