This paper demonstrates the low voltage operation of a doubly balanced Gilbert mixer fabricated in a 0.8m CMOS process and operating as both a down-converter and an upconverter. As a down-converter with an RF input of 1.9 GHz, the mixer has a single sideband noise figure as low as 7.8 dB and achieved down-conversion gain for supply voltages as low as 1.8 V. As an up-converter, the mixer demonst...

The present study proposes a new nonisolated DC-DC high step-up converter for solar PV power plant applications using the voltage boosting technique. output gain of this is and stress on switch diodes acceptable. proposed has easier control. Moreover, to achieve higher reliability, uses common ground between load source. Voltage analysis, proper component selection, evaluation are performed in ...

Within the photovoltaic (PV) power-generation market, the ac PV module has shown obvious growth. However, a high voltage gain converter is essential for the module’s grid connection through a dc–ac inverter. This paper proposes a converter that employs a floating active switch to isolate energy from the PV panel when the ac module is OFF; this particular design protects installers and users fro...

This paper proposes a new high step-up DC–DC converter designed especially for regulating the dc interface between various micro sources and a dc–ac inverter to electricity grid. The need of Electricity increases the power demand where the power demand met by the conventional sources of energy has some disadvantage of pollution, this disadvantage can be decreased by the use of the Renewable ene...

A new circuit technique for voltage gain enhancement in CMOS op amp design suitable for low voltage and high speed operation is presented in this paper. A negative conductance is used to cancel the positive output conductance of an amplifier thereby reducing the total equivalent output conductance and increasing the voltage gain of the amplifier. The negative conductance is derived from the out...

A low-voltage low-power CMOS operational transconductance amplifier (OTA) with near rail-to-rail output swing is presented in this brief. The proposed circuit is based on the current-mirror OTA topology. In addition, several circuit techniques are adopted to enhance the voltage gain. Simulated from a 0.8-V supply voltage, the proposed OTA achieves a 62-dB dc gain and a gain–bandwidth product of...

An observer controller for a buck converter is presented. A state feedback gain matrix is derived in order to achieve the stability of the converter and to ensure the robustness of the controller. A load estimator is designed to estimate the unmeasurable variables and to obtain the zero output voltage error. A pulse-width modulation scheme is adopted to obtain the output voltage regulation. In ...

This paper presents a high step-up boost converter with diode capacitor technique. In this topology an additional stage of voltage multiplier cells (diodes and capacitors) is incorporated into the conventional boost converter which will increase the voltage gain and efficiency of the converter. The peculiarity of this new method is that the switching losses, ripples and the stresses are low. An...

A CMOS implementation of a high-gain current mode operational amplifier (opamp) with a single-ended input and a differential output is described. This configuration is the current mode counterpart of the traditional voltage mode opamp. In order to exploit the inherent potential for high speed, low voltage operation normally associated with current mode analog signal processing, the opamp has be...

An easy dc-dc boost converter is unable to give high step-up voltage gains due to the effect of power switches, rectifier diodes, and the equivalent series resistance of inductor and capacitors. In this paper proposes new dc-dc converter to achieve high voltage gain without an extremely high duty ratio. In the proposed converters, two inductors with the same level of inductance are charged in p...