This work presents the procedure qualification for pipeline orbital welding using a robotic system. The system has four degrees of freedom, which allow the controlling of the stick out, the travel speed, the torch angle and the positioning. The arc voltage and welding current are also controlled during the welding, although the system uses a conventional power source. With the system it is poss...

The detection and classification of the defects in the welded components are very important in order to ensure the structural integrity of the fabricated components of the test blanket module (TBM). RAFM steel is used as structural material for the TBM, therefore ultrasonic based technique are the most suitable for high sensitive defect detection. In this work ultrasonic pulse echo technique is...

For hot extrusions of magnesium alloy sheets, Dissimilar AZ80 and AZ31 were used, in which AZ80 was placed on advancing side and AZ31 on retreating side, using friction stir butt welding with different process parameters. Some defect-free welded joints with good weld surfaces could be obtained with some suitable welding conditions. The maximum tensile strength of welded joint which is 225.5 MPa...

Tailor Welded Blanks (TWBs) made of dissimilar, uniform or non uniform thickness materials have potential applications in automobile industries for light weight materials in order to improve fuel efficiency and cost of carrier. The focus of this paper is to develop and present analytical model to determine total elongation of tailor welded blank (TWBs). The validation of this method is done by ...

Hydraulic support is the main supporting equipment of the coal mining systems, and they are usually subjected to fatigue failure under the high dynamic load. The fracture positions are generally at welded joints where there is a serious stress concentration. In order to investigate and further improve the fatigue strength of hydraulic support, the present work first located the possible positio...

Study on corrosion propensity of welded mild steelbar in soil media around the coastal area of University of Lagos has been carried out using gravimetric method. Six (6) samples each for welded and unwelded mild steels were cut, their initial weights were recorded and buried in two selected soil. The weight losses of these coupons were measured at regular intervals for a period of six months (1...

The investigation of fatigue strength needs an accurate solution and reliable values of the stress intensity factor (SIF). In this study, SIF of load-carrying cruciform welded joints has been evaluated using finite element method (FEM), and compared with the available solutions from literature. Load-carrying cruciform welded joints with isosceles triangles and non-isosceles triangle fillet weld...

A Nd:YAG laser was used for joining a pseudoelastic Ti-51.5 at.% Ni shape memory alloy. Tensile tests on sheet metal of 0.5 mm thickness were performed at temperatures of -40°C, +20°C and 1 10°C, representing the martensitic, pseudoelastic and austenitic condition, respectively. Laser-welded specimens exhibited an ultimate tensile strength of about 820 MPa not affected by the test tempefature. ...

U.S. Department of the Interior U.S. Geological Survey Wheeler Geologic Monument (Half Moon Pass quadrangle) provides exceptional exposures of three outflow tuff sheets erupted from the San Luis caldera complex. Lowest sheet is Rat Creek Tuff, which is nonwelded throughout but grades upward from light-tan rhyolite (~74% SiO 2 ) into pale brown dacite (~66% SiO 2 ) that contains sparse dark-brow...