We have fabricated the transparent bottom gate and top gate TFTs using new oxide material of Al-Zn-Sn-O (AZTO) as an active layer. The AZTO active layer was deposited by RF magnetron sputtering at room temperature. Our novel TFT showed good TFT performance without post-annealing. The field effect mobility and the sub-threshold swing were improved by the post-annealing, and the mobility increase...

A rapid, wafer-level, dry process for in-situ synthesis, deposition of stable nanostructured, porous metal-oxide films for gas sensors is presented. Lace-like, nanostructured films of pure SnO2 featuring high porosity (98%) are selfassembled on a target substrate by flame spray pyrolysis (FSP). The nanoparticles are mainly polyhedral and monocrystalline with a grain size of 8.7 nm and crystal s...

A general and facile one-pot template-free hydrothermal strategy has been developed to synthesize various metal oxide (TiO2, SnO2 and α-Fe2O3) hollow spheres with unified morphologies. The formation of hollow structure involves a trifluoroacetic acid (TFA)-assisted Ostwald ripening process. Photocatalytic activities of the as-prepared TiO2 product are evaluated by the photodegradation of Rhodam...

Semiconducting nanoparticle tin oxide-based sensors have been prepared with a pressure load of 4, 6, 8, 10 tons and reinforced with carbon nanofibers (CNF) in SnO2 matrix. The SnO2/CNF sensor’s sensitivity for ethyl alcohol has increased by a factor of two, in compared with that of pure SnO2 8-ton pressed sensor with lower response time. These results open the way towards further optimized lowe...

Tribological properties of nanolamellar tungsten disulfide doped with zinc oxide nanoparticles were studied. Nanolamellar tungsten disulfide and ZnO nanoparticles produced by electrospark erosion of metal granules in an H2O2 solution were analyzed using the XRD, SEM and TEM techniques. According to the tribological measurements, ZnO nanoparticles did not significantly change the friction coeffi...

Highly crystalline metal oxide nanoparticles such as CoO, ZnO, Fe(3)O(4), MnO, Mn(3)O(4), and BaTiO(3) were synthesized in just a few minutes by reacting metal alkoxides, acetates or acetylacetonates with benzyl alcohol under microwave heating.

During the past decades, numerous achievements concerning luminescent zinc oxide nanoparticles (ZnO NPs) have been reported due to their improved luminescence and good biocompatibility. The photoluminescence of ZnO NPs usually contains two parts, the exciton-related ultraviolet (UV) emission and the defect-related visible emission. With respect to the visible emission, many routes have been dev...

Efficient conversion of solar energy into useful chemical fuels is a major scientific challenge. Water-splitting dyesensitized photoelectrochemical cells (WS-DSPECs) utilize mesoporous oxide supports sensitized with molecular dyes and catalysts to drive the water-splitting reaction. Despite a growing body of work, the overall efficiencies of WS-DSPECs remain low, in large part because of poor e...

Traditional methods of synthesis of metal-oxide gas sensing materials for semiconductor sensors are based on wet sol-gel processes. However, these processes lead to the formation of hydroxyl groups on the surface of oxide particles being responsible for the strong response of a sensing material to humidity. In this work, we investigated the possibility to synthesize metal-oxide materials with r...

In order to elucidate the effect of sodium on the activity of ZSM-5 supported metal oxides catalysts (ZnO-Al2O3/ZSM-5 and SnO-Al2O3/ZSM-5) for the transesterification of soybean oil with methanol, ZSM-5 supported metal oxides were prepared with and without sodium hydroxide by impregnation. The metal compositions of the ZSM-5 supported metal oxide catalysts and the metal concentrations dissolved...