Land application of cattle slurry can result in incidental and chronic phosphorus (P) loss to waterbodies, leading to eutrophication. Chemical amendment of slurry has been proposed as a management practice, allowing slurry nutrients to remain available to plants whilst mitigating P losses in runoff. The effectiveness of amendments is well understood but their impacts on other loss pathways (so-...

High entropy alloys (HEAs) are novel materials that have been extensively studied in recent years. In this work, Al2O3 particles reinforced FeCoNiCrMn HEA composite coatings were fabricated by cold spray. The microstructure, mechanical and tribological properties of the composites coating compared with those pure coating. results indicate spray is a promising process to fabricate coatings. made...

the vibratory finishing is one of the important mass finishing processes. this can be applied for finishing many metallic and non- metallic components using abrasive materials such as steel, ceramic, natural materials and etc. the vibratory finishing process is used for some purposes such as surfaces polishing, deburring, oxide layer removing and rounding the edges. evaluation of surface roughn...

The fate of 15NH4-N labelled cattle slurry applied before sowing in September of a winter wheat crop was studied on a loamy sand soil. The aim was to quantify immobilization of slurry 4 into microbial biomass, the speed at which nitrate derived from the slurry NH4-N was transported down the soil profile, and the utilization of slurry 4 by the winter wheat crop. Cattle slurry was applied at a ra...

The potential for the transport of viable Cryptosporidium parvum oocysts through soil to land drains and groundwater was studied using simulated rainfall and intact soil columns which were applied raw slurry or separated liquid slurry. Following irrigation and weekly samplings over a 4-week period, C. parvum oocysts were detected from all soil columns regardless of slurry type and application m...

In this research, the effect of annealing heat treatment on microstructure, mechanical properties and wear behavior an Al–Zn–Mg/3 wt.% Al2O3 composite that was previously thermomechanically processed (TMPed) in its semisolid temperature range investigated. The conducted at 400 ˚C for 15, 30, 45 60 min, respectively. results revealed led to better distribution alumina reinforcement particles. Al...

Production of abrasive materials includes the stages: covering of abrasive material with wetting agent, addition of binder, i.e. the filler with the binding material, mixing of the components, stabilization to achieve homogeneity of composition, and hardening. The most important processes affecting the properties of the final product are: the coverage of the abrasive materials, mixing, and prop...

* Corresponding author. E-mail address: [email protected] 1537-5110/$ – see front matter a 2008 IAgrE doi:10.1016/j.biosystemseng.2008.12.003 Acidification of pig slurry to pH 5.5 is used as a measure to reduce ammonia emission from pits and storages. The slurry is acidified with sulphuric acid in a process tank and pumped back to the slurry pits or to a storage tank. We investigated th...

The paper discusses the material removal process in refractory ceramics eroded by hydro-abrasive jets. In particular, bauxite, sintered magnesia, and magnesia chromite are eroded. The influence of abrasive particle velocity, local exposure time, abrasive mass-flow rate, and abrasive type is investigated. Erosion depth, specific erosion rate, and geometry of the generated cavities are measured a...

Slurry acidification using sulfuric acid reduces ammonia emissions but also affects sulfur (S) cycling. Emission of sulfur is a source of malodor and reduces the sulfur fertilizer value of the slurry. We investigated the effect of sulfate and methionine amendments, alone or in combination with acidification, on sulfur transformations in slurry and emissions of volatile sulfur compounds (VSC) du...