In this study, Aluminium2024- Graphite composites containing 5, 10, 15 and 20 weight percent of graphite were produced by solid assisted melt disintegration (SAMD) technique which resulted in production of Al/Gr powder mixtures which subsequently consolidated and sintered for preparation of Al/Gr composites. In this technique, powder mixture was prepared by addition of flake graphite (mean diam...

William G. Fahrenholtz o 9m Ceramic Engineering Department ‘so University of Missouri-Rolls w~!!l Rolls, MO 65409 + <. +# Metal-reinforced Alz03-matrix composites were prepared using reactive hot pressing. The volume fraction of the reinforcing phase was controlled by the stoichiometry of the particular displacement reaction used. Dense Alz03-Ni and Al@3-N’b composites were fabricated using thi...

Antimicrobial chemokines (AMCs) are a recently described family of host defense peptides that play an important role in protecting a wide variety of organisms from bacterial infection. Very little is known about the bacterial targets of AMCs or factors that influence bacterial susceptibility to AMCs. In an effort to understand how bacterial pathogens resist killing by AMCs, we screened Yersinia...

Aluminum lamination was performed to improve the physical and mechanical properties of several wood-based composite panels. The panels were aluminum-laminated on two faces in a hot press at 689 kPa and 120 °C for 6 min. Four types of wood-based composites were used as cores, and aluminum 3003 alloy sheets were used for face laminations. Polyurethane adhesive ensured bonding strength between the...

This study evaluated the effect of surface finishing methods on the average surface roughness of resin composites. Seven composites and two polishing systems were used. One hundred and twenty-six conical specimens of each material were prepared in stainless steel molds against a polyester strip. Forty-two of them remained intact and were used as controls. Each half of the remaining samples was ...

For the past decades researchers are showing immense interest to investigate the natural advantage of preparation of composites from minerals such as bauxite particles, and proved their effectiveness as cost effective reinforcing agents in fabrication of high performance composites. This study, is a new attempt in using the Iraqi natural bauxite powder with different proportions (2wt%, 4wt%, an...

In the present work, an aluminum metal matrix reinforced with (Al₂O₃) nanoparticles was fabricated as a surface composite sheet using friction stir processing (FSP). The effects of processing parameters on mechanical properties, hardness, and microstructure grain were investigated. The results revealed that multi-pass FSP causes a homogeneous distribution and good dispersion of Al₂O₃ in the met...

Amniotic membrane-derived mesenchymal cells (AMCs) are considered suitable candidates for a variety of cell-based applications. In view of cell therapy application in uterine pathologies, we studied AMCs in comparison to cells isolated from the endometrium of mares at diestrus (EDCs) being the endometrium during diestrus and early pregnancy similar from a hormonal standpoint. In particular, we ...

INTRODUCTION JET-Fresh (Dentsply International, York, PA), a new airpolishing powder that contains aluminum trihydroxide as the abrasive agent, has been introduced for use with Prophy-Jet trade mark (Dentsply International). PURPOSE The aim of this study was to investigate the surface effects of aluminum trihydroxide airpolishing powder on a series of restorative materials. MATERIALS AND ME...

Aluminum matrix composites are key materials used in the preparation of lightweight structural parts. It has advantages low density, high specific strength, and stiffness. Additionally, its friction wear properties important factors that determine material’s suitability for use a batch. Therefore, this paper systematically analyzes current research on behavior particle-reinforced aluminum compo...