This research discusses developing an Euler turbine-based hybrid mesh turbomachinery. Within the framework of mechanical engineering science, turbomachinery classification and a novel method for design were considered. In such turbomachine, large blades are replaced by set smaller blades, which interconnected to form flow channels in structure. Previous studies (and reasoning within inductive d...

A comprehensive finite element methodology is developed to predict the compressible flow performance of a non-symmetric 7-blade axial flow fan, and to quantify the source strength and sound pressure levels at any location in the system. The acoustic and flow performances of the fan are predicted simultaneously using a computational aero-acoustic technique combining transient flow analysis and n...

Characteristics of rotor blade tip clearance flow in axial compressors can significantly affect their performance and stable operation. It may also increase blade vibrations and cause detrimental noises. Therefore, this paper is contributed to investigate tip leakage flow in a low speed isolated axial compressor rotor blades row. Simulations are carried out on near-stall condition, which is val...

Abstract Turbomachinery blade rows can have non-uniform geometries due to design intent, manufacture errors or wear. When predictions are sought for the effect of such non-uniformities, it is generally case that whole assembly calculations needed. A spectral method used in this paper approximate flow fields but with significantly less computation cost. The projects perturbations geometry non-un...

Experiments were conducted to investigate local heat transfer coefficients and flow characteristics of air flow in a 962 lm inner diameter stainless steel microtube (minichannel). The effects of heat loss, axial heat conduction and viscous heating were systematically analyzed. Heat losses during the experiments with gas flow in small diameter tubes vary considerably along the flow length, causi...

Measurements of film mass flow rate for annular, diabatic steam-water flow in tubes are presented. The measurements were carried out with four axial power distributions and at several axial positions at conditions typical for boiling water reactors, i.e. 7 MPa pressure and total mass flux in a range from 750 to 1750 kg/ms. The results show that the influence of the axial power distribution on t...

On the basis of small axial fan with five blades, 6 types of small axial flow fans with different chord lengths splitter blades were designed. Numerical simulation of 6 fan models with splitter blades and prototype fan were done by using Fluent. Based on the obtained simulation results, internal flow characteristics and aerodynamic noise were analyzed and compared. It indicates that: splitter b...

In the present study, finite element calculations are performed of blood flow in the carotid artery bifurcation under physiological flow conditions. The numerical results are compared in detail with laser-Doppler velocity measurements carried out in a perspex model. It may be concluded that the numerical model as presented here is well capable in predicting axial and secondary flow of incompres...