This paper presents a power factor corrected (PFC) bridgeless (BL) buck–boost converter-fed brushless direct current(BLDC) motor drive as a cost-effective solution for low-power applications. An approach of speed control of the BLDC motor by controlling the dc link voltage of the voltage source inverter (VSI) is used with a single voltage sensor. This facilitates the operation of VSI at fundame...

A new method to control the Buck converter using new small signal model of the pulse width modulation (PWM) switch is introduced. The new method uses recurrent supervised neural network to estimate certain parameters of the transformed system matrix [ A~ ]. Then, linear matrix inequality (LMI) optimization is used to obtain the permutation matrix [P] so that system transformation {[ B~ ], [ C~ ...

This paper aims to design a PID compensator for the control of Synchronous Rectifier (SR) Buck Converter to improve its conversion efficiency under different load conditions. Since the diode rectifier is replaced by a high frequency MOSFET switch, the SR control method itself will be sufficient under heavy load condition, to attain better normal mode performance. However, this technique does no...

This paper presents a power factor corrected (PFC) bridgeless (BL) buck–boost converter-fed brushless direct current (BLDC) motor drive as a cost-effective solution for low-power applications. An approach of speed control of the BLDC motor by controlling the dc link voltage of the voltage source inverter (VSI) is used with a single voltage sensor. This facilitates the operation of VSI at fundam...

In this study, a modified design of two-switch buck-boost (TSBB) converter is proposed to improve power efficiency using fewer conduction components, and the optimal range measured. The TSBB operates in three topologies: buck, boost, buck-boost, like conventional converter. However, improves buck topologies by decreasing loss diode switch-off section while maintaining same number semiconductors...

This work presents the analysis of radiated EMI problems associated with DC-DC buck converters and the solutions for minimize the reverse recovery of the Drain-Bulk diode of the synchronous switching MOSFET. The DC-DC buck converter topology is used in computers and telecom applications because of its high power efficiency and multiple DC levels. For reducing the reverse recovery and its relate...

Addition of an input filter to a current-programmed converter can cause the controller to oscillate. Two instability mechanisms can typically occur: 1) the current programmed controller effective current feedback loop may become unstable, or 2) the controller effective input voltage feed forward loop, which becomes a positive feedback loop when an input filter is added, may oscillate. Design cr...

Nonlinear systems, such as switching DC-DC boost or buck converters, have rich dynamics. A simple one-dimensional discrete-time model is used to analyze the boost or buck converter in discontinuous conduction mode. Seven different control schemes (open-loop power stage, voltage mode control, current mode control, constant power load, constant current load, constanton-time control, and boundary ...

This paper presents the implementation of a bidirectional dc-dc converter to protect a battery from overcharging and undercharging. The proposed converter circuit provides low voltage stresses across the switches, higher step-up and step-down voltage gains and efficiency is also high when compared to conventional boost/buck converter. The proposed control circuit controls the charging and disch...