We present dewar temperature and system temperature measurements for the eight cryogenically cooled receivers of a subset of four EVLA antennas that have undergone a reconfiguration to use three cryogenic compressors instead of four. We compare the changes in the system temperatures in these antennas with those obtained from a subset of eight other EVLA antennas that have not undergone such a r...

In accordance with worldwide consensus, the use of chlorofluorocarbons, which play an important role in damaging the ozone layer, should be completely abolished by the end of 1995. This provided the impetus for developing the three vane rotary compressor. Formerly CFC-12 was used as the refrigerant in automotive air conditioners, until HFC-134a was substituted for CFC-12. In response to the cha...

In this paper we give insight into characteristics of a 1.5-stage transonic axial compressor rig with focus on surge during stalled operating point. The new at TU Darmstadt is representative for the front stage an industrial gas turbine. Transient throttling maneuvers were conducted multiple points first test campaign TCD 2 (Transonic Compressor 2), providing extensive set unsteady structural a...

Hydrogen fuel consumption measuring methodologies of a cell vehicle without modifying the path has been tested and benchmarked. In this work, they are applied to Hyundai Nexo electric driving different mission profiles on chassis dynamometer. Three methods respectively based hydrogen tank pressure, tailpipe oxygen concentration, IR-shared (infrared) data compared reference method relying curren...

Fouling is the most important performance degradation factor, so it is necessary to accurately predict the effect of fouling on engine performance. In the previous research, it is very difficult to accurately model the fouled axial flow compressor. This paper develops a new performance calculation method of fouled multistage axial flow compressor based on experiment result and operating data. F...

Gas turbine inlet fogging and overspray (high-fogging) have been considered the most cost-effective means of boosting a gas turbine’s total power output, especially under hot or dry weather conditions. The result of employing fogging or overspray is indisputably clear − total power output is increased; however, development of the theory and explanation of the phenomena associated with fogging a...

This paper presents some of the results from a Master’s thesis research into the performance and operation of a centrifugal compressor at off-design operating conditions using advanced computational fluid dynamics (CFD) techniques. ANSYS CFX is the CFD solver used in this blind study to evaluate the ability of modern CFD software to predict the performance of centrifugal compressors operating a...

The screw compressor in the early stage of development is generally known as the oil-injection type. However, escalating environmental problems and advances in electronic components have spurred continuous R & D to minimize the oil content in compressed air. The oil-free twin-screw compressor is continuously compressed by inner volumetric change between rotors and casing. Fo this reason, in ord...

In this paper we present an adaptive method for image compression that is based on complexity level of the image. The basic compressor/de-compressor structure of this method is a multilayer perceptron artificial neural network. In adaptive approach different Back-Propagation artificial neural networks are used as compressor and de-compressor and this is done by dividing the image into blocks, c...

H. Doyle Thompson Dept. of Mechanical Engineering Purdue University W. Lafayette, IN 47907 .(317) 494-5624 Heat transfer to the suction gas in a hermetic compressor is known to have adverse effects on compressor performance. This can be explained in an overall sense by thermodynamic cycle analysis. The extent of suction gas heated. inside the compressor and the areas in which this heating occur...