in this study, damar batu (db) − a novel biomaterial− is evaluated for its potential application in pharmaceutical coating. db is a whitish to yellowish resin, characterized initially in terms of solubility, acid value, molecular weight (mw), polydispersity index (mw/mn) and glass transition temperature (tg). neat plasticized films of db are investigated for mechanical, water vapor transmission...

In the present paper, formation of protective coatings on MA8 magnesium alloy by plasma electrolytic oxidation (PEO) with subsequent treatment fluoropolymer is considered. The morphology after accelerated climatic tests was investigated and elemental composition studied in a salt spray chamber (SSC). analysis obtained results demonstrated higher corrosion resistance fluoropolymer-containing lay...

In the field of orthopedics, magnesium (Mg) and magnesium-based composites as biodegradable materials have attracted fundamental research. However, the medical applications of magnesium implants have been restricted owing to their poor corrosion resistance, especially in the physiological environment. To improve the corrosion resistance of Mg/HA/TiO2 nanocomposites, monolayer MgO and double-lay...

In the current study, a sol-gel-synthesized tricalcium magnesium silicate powder was coated on Ti-6Al-4V alloys using plasma spray method. Composition of feed powder was evaluated by X-ray diffraction technique before and after the coating process. Scanning electron microscopy and atomic force microscopy were used to study the morphology of coated substrates. The corrosion behaviors of bare and...

A β-Ta nanocrystalline coating was engineered onto a Ti-6Al-4V substrate using a double cathode glow discharge technique to improve the corrosion resistance and bioactivity of this biomedical alloy. The new coating has a thickness of ~40 μm and exhibits a compact and homogeneous structure composed of equiaxed β-Ta grains with an average grain size of ~22 nm, which is well adhered on the substra...

Adhesion strength of exterior or interior coating of steel pipes is too important. Increasing of coating adhesion on surfaces can increase the life time of coating, safety factor of transmitting line pipe and decreasing the rate of corrosion and costs. Preparation of steel pipe surfaces before doing the coating process is done by shot and grit blasting. This is a mechanical way to do it. Some e...

Aluminum coating was prepared on AZ91D magnesium alloy substrate using the electrophoretic deposition (EPD) method in absolute ethanol solvent. In order to determine the optimal concentration of AlCl3.6H2O additive, the zeta potential and size of particles in the suspension were measured in the presence of different concentrations of AlCl3.6H2O. The results showed that an appropriate coating is...

Polymeric film coatings were applied by dip coating on two magnesium alloy systems, AZ31 and Mg4Y, in an attempt to slow the degradation of these alloys under in vitro conditions. Poly(lactic-co-glycolic acid) polymer in solution was explored at various concentrations, yielding coatings of varying thicknesses on the alloy substrates. Electrochemical corrosion studies indicate that the coatings ...

Turbine blades must withstand severe loading conditions and damage can occur during operation due to heat, pressure, foreign objects hot gas corrosion, despite the protective coatings applied onto turbine blades. Instead of replacing damaged components, maintenance, repair overhaul are key extend total service life. Besides welding, by brazing is an established process in industry involves many...

Aluminum (Al) and Al alloys exhibit unusual passivity when immersed in alkaline lithium (Li) salt solutions. This passivity is a result of precipitation of a continuous, polycrystalline talc coating. Talc coatings persist when removed from the Li salt solution and offer increased corrosion protection during exposure to aggressive environments. Efforts to develop a low-cost, low-toxicity, easily...