Cancer cells are preferentially killed by anticancer agents because key signals for growth and cell division are "always on" as opposed to the alternative "on" and "off" signaling of normal cells. Too much of today's anticancer drug discovery effort may go toward reversing genetically promoted "always on" signals. More effective anticancer drug targets may be found through use of RNAi technolog...

The clinical success of direct composite restorations is the result of the correct use and performance of adhesive systems, resin composites and light curing systems. Total-etch adhesive systems and microhybrid resin composites have seen continuous improvement; various clinical techniques have been introduced to address polymerization shrinkage. Manufacturers have introduced sophisticated light...

A prediction method for rubber curing process has historically received considerable attention in manufacturing process for rubber article with relatively large size. In recent years, there exists increasing demand for simulation driven design which will cut down the cost and time required for product development. In case of the rubber with relatively large dimensions, low thermal conductivity ...

We present a printable interdigital structure, integrated into the surface of a component, to monitor the curing of two adhesively joint components during the fabrication process. In the factory of the future there is a need of new sensor concepts beside the information technological infrastructure. Monitoring of the fabrication enables automated control of the process which improves the qualit...

Two strains of Staphylococcus aureus (PC1 and 196E), when grown in medium containing 0.002% sodium dodecyl sulfate (SDS), showed from 96.1 to 100% loss of the ability to produce penicillinase. Resistance to cadmium and zinc was lost concomitantly with the ability to produce penicillinase. A comparison of the rate of curing by SDS with the curing effects exerted by elevated temperature and ethid...

The objective of this study is to use differential scanning calorimetry (DSC) to characterize the curing kinetics of Al2O3 and hydroxyapatite suspensions in acrylates. The heat evolution of the acrylate premix and ceramic suspensions in dynamic and isothermal curing was measured. The calculated activation energies for the acrylate premix and the two ceramic suspensions were 133, 74, and 78 kJ/m...

in this article the transient heat transfer in rubber parts has been studied. this study is usefull for estimation of the minimum curing time of the rubber parts and thereby to ensure the quality of the rubber. also is the temperature distribution during the rubber curing is well know, then the curing time could accurately be estimated, which will lead to a better curing process. in this regard...

statement of problem: the degree of conversion depends on the material composition, light source properties, distance from light source, light intensity, curing time, and other factors such as shade and translucency. objectives: in the present study, we evaluated the effects of different light- curing modes and shades of methacrylate and silorane-based resin composites on the degree of conversi...