Abstract—The wear measuring and wear modelling are fundamental issues in the industrial field, mainly correlated to the economy and safety. Therefore, there is a need to study the wear measurements and wear estimation. Pin-on-disc test is the most common test which is used to study the wear behaviour. In this paper, the pin-on-disc (AEROTECH UNIDEX 11) is used for the investigation of the effec...

The study aims to investigate the influence of environmental media on friction and wear behavior low-alloy wear-resistant steels provide practical references for their application. This article conducted sliding tests NM500 steel under different loads air atmosphere, deionized water, 3.5 wt% NaCl solution conditions. Someone quantitatively measured coefficient amount each pair. present employed...

In this paper, the gear material 20CrMnTi was selected as the research object. Friction and wear behavior was performed on the M2000 friction and abrasion tester. The friction and wear mechanisms of 20CrMnTi steel were discussed under coupling of rolling and sliding. The results show that damage of steel-steel couples under coupling of rolling and sliding is caused by the interaction of mechani...

Ni-W coatings, compared to pure nanocrystalline Ni, exhibit higher hardness and wear resistance. In some cases, these coatings are considered as environmental friendly alternatives for hard chromium coating. Till now, most of Ni-W coatings have been produced by direct current electrodeposition from alkaline baths. In this study square pulse current was used for deposition of Ni-W precipitates f...

Introduction: Crosslinking of polyethylene has been known for decades to improve the abrasion resistance of the polymer for industrial applications. However, only three applications of this technology have been reported in use in total hip replacements in the orthopaedics literature by Grobbelaar et. al. [1], Oonishi et. al. [2], and Wroblewski et. al. [3]. Recently, the interest in highly cros...

After total hip replacement, some cemented titanium stems show above-average early loosening rates. Increased release of wear particles and resulting reaction of the peri-prosthetic tissue were considered responsible. The objective was to develop a test method for analysing the abrasive wear behaviour of cemented stems and for generating wear particles at the interface with the bone cement. By ...

Over the past three decades more than a half a million joint replacements have been performed. Several advances have been made to the design of the implants, but despite the large success of these procedures, loosening of the components and periprosthetic osteolysys often requires a revision surgery. In looking at what causes this, the wear of the UHMWPE articulation surface and the associated ...

Abstract Impact–sliding caused by random vibrations between tubes and supports can affect the operation of heat exchangers. In addition, a corrosive environment cause damage, accelerating synergism corrosion wear. Therefore, focus this work was impact–sliding fretting tribocorrosion behavior 316L exchanger at different halide concentrations. A device system incorporating in situ electrochemical...

A computational model of a planetary gear set is employed to study the influence of surface wear on the dynamic behavior of a typical planetary gear set. The overall computational scheme combines a wear model that defines geometric description of contacting gear tooth surfaces having wear and a deformable-body dynamic model of a planetary gear set. The wear model employs a quasi-static gear con...