Future interferometric synthetic aperture radar (InSAR) systems require electronically scanned phased-array antennas, where the transmit/receive (T/R) module is a key component. The T/R module efficiency is a critical figure of merit and has direct implications on the power dissipation and power generation requirements of the system. Significant improvements in the efficiency of the T/R module ...

We developed a 1.5 μm eye-safe wavelength high-gain and high-average power laser amplifier using an Er,Yb:glass planar waveguide for coherent Doppler LIDAR. Applying the planar waveguide structure, high-average output power with near single transverse mode was realized. Consequently, high-gain and high-efficient operation were achieved by multi-bounce optical path configuration. Amplifying the ...

this paper presents a novel fully differential (FD) ultra high common mode rejection ratio (CMRR) current operational amplifier (COA) with very low input impedance. Its FD structure that attenuates common mode signals over all stages grants ultra high CMRR and power supply rejection ratio (PSRR) that makes it suitable for mixed mode and accurate applications. Its performance is verified by HSPI...

--This paper describes the design and analysis of High gain and widest bandwidth operational amplifier for Analog to Digital conversion application. Different Techniques are used to enhance the output characteristics performance. These amplifiers demonstrate the highest frequency and widest bandwidth of operation for amplifier using reduced complexity algorithm. This paper presents an improved ...

In order to design and optimize high-linearity power amplifier (PA), which with nonlinear and memory effect, it is very important to build power amplifier behavior modeling accurately. This paper proposes a power amplifier behavior modeling based on RBF neural network with improved chaos particle swarm optimization algorithm. To make the particles evenly distribute in the problem search space, ...

Accurate FET Model parameters need to be determined to give accurate simulation results for RF amplifiers. The accuracy required varies depending on the application of the final amplifier. For Doherty amplifiers, a high accuracy is required for the transfer characteristic of the amplifier. An amplifier was simulated using a model obtained from data sheet information, and then built. Measurement...

A complementary bipolar low-power, high-speed, current-feedback operational amplifier is described. The amplifier incorporates a new Class AB output stage that enables high output current drive of 100 mA and large voltage swing within 1 V of the supply rails while operating at low quiescent current of 1.5 mA. The amplifier was fabricated in a junction-isolated complementary bipolar process with...