The purpose of this research was to determine the shear strength of a unidirectional carbon-®bre/epoxy composite by means of the 10 o€-axis and 0 Iosipescu specimens subjected to shear. Detailed non-linear ®nite-element computations of these two tests were conducted, taking into account the actual non-linear material behavior of the composite. The tests were compared in terms of stresses and st...

A shear-lag model with a cohesive fibre–matrix interface has been developed for the analysis of stress transfer between the fibre and the matrix in fibre-reinforced composites in this paper. A bilinear cohesive damage evolution law is used to describe the fibre–matrix interface behaviour. The governing equations for the interfacial shear stress and the axial stress in the fibre are derived. Acc...

INTRODUCTION In the normal hip, stress is distributed over the entire crossection of the femur. Bending and axial compression are the major modes of loading. Following THA, the stress in the bone is significantly different mainly due to the manner in which the load is transferred to the femur (Huiskes, 1990, Huiskes, 1995). In this case, the load is primarily transferred through shear across th...

When loaded in simple shear deformation, polymeric materials may develop so-called normal stresses: stresses perpendicular to the direction of the applied shear. These normal stresses are intrinsically nonlinear: basic symmetry considerations dictate they may only enter at O(γ(2)), with γ the dimensionless shear strain. There is no fundamental restriction on their sign, and normal stresses may ...

Biomass tensile and shear ultimate failure stresses were measured with the aim of identifying biomass ‘‘weakest mode of failure’’ or ‘‘natural fracture point’’ as a basis for future grinder designs. Switchgrass (Panicum virgatum L.) ultimate stresses were determined for Alamo and Kanlow varieties over ranges in maturity and moisture content. Alamo had greater ultimate tensile stress than Kanlow...

Interstitial flow is an important regulator of various cell behaviors both in vitro and in vivo, yet the forces that fluid flow imposes on cells embedded in a 3D extracellular matrix (ECM), and the effects of matrix architecture on those forces, are not well understood. Here, we demonstrate how fiber alignment can affect the shear and pressure forces on the cell and ECM. Using computational flu...

We perform molecular dynamics simulations on a bead-spring model of pure polymer grafted nanoparticles (PGNs) and of a blend of PGNs with a polymer melt to investigate the correlation between PGN design parameters (such as particle core concentration, polymer grafting density, and polymer length) and properties, such as microstructure, particle mobility, and viscous response. Constant strain-ra...

*Correspondence: Marcelo J. Dapino, 201 West 19th Avenue, Columbus, OH 43210, USA e-mail: [email protected] Shape memory composites (SMCs) based on shape memory alloys (SMAs) and shape memory polymers (SMPs) allow many design possibilities due to their controllable temperature-dependent mechanical properties. The complementary characteristics of SMAs and SMPs can be utilized in systems with shap...

We have shown that leukocytes retract their pseudopods and detach from substrates after exposure to physiological fluid shear stresses ( approximately 1.5 dyn/cm(2)). In inflammation, however, pseudopod projection during spreading and firm adhesion on endothelium is observed even in microvessels with normal blood flow and fluid shear stresses. Thus, we examined mechanisms that may serve to regu...