This paper proposes a bi-directional isolated DC/DC converter for the battery charger and discharger of Electric Vehicle to reduce power loss under light loads. The proposed consists two full-bridge inverters, an transformer, boost reactor, provides transmission, buck-boost conversion, zero-voltage-switching reactive suppression. Two semiconductors inverter in rectification side are turned off ...

UAV aircraft with a fixed wing configuration multi-rotor are capable of vertical take-off and landing (VTOL). In designing the structure aircraft, weight factor strength factors that need to be considered. The use sandwich composite materials on wings is expected able meet requirements namely having light weight, high rigidity strength. this study, comparative analysis balsa wood VTOL VX-2 was ...

although bearing capacity of footings on top of slopes under monotonic loadings have been investigated widely so far, safety and bearing capacity of these structures against repeated dynamic loads have not been considered well enough. in this paper, lower bound dynamic shakedown theorem in its numerical form has been employed to firstly obtain bearing capacity of strip footings on top of slopes...

it is proposed to use a single base platform in the persian gulf considering its low depth and more appropriate environmental conditions in comparison to north sea and mexico gulf where this kind of platform is very popular. the pile of platform is responsible for transmission of environmental loads resulted from waves, currents, wind and dead loads to foundation of platform. using sacs 5.3 sof...

We compared two sets of loading conditions for their effect on the mechanical performance of isolated rat trabecular muscle: (1) loading which approximated that of the intact ventricle; (2) nonphysiological afterloaded isotonic contractions. Improved performance, manifested by increased shortening and rate of shortening at constant load, was seen when lengthening occurred at light loads, as in ...

We analyzed the evolution of viral tropism after 8 days of maraviroc monotherapy, i.e., we used the maraviroc clinical test (MCT), in 21 patients with and 14 without virological response to the drug (MCT(+) and MCT(-) patients, respectively). No increases in CXCR4 inferred viral loads (X4IVLs) were observed in MCT(+) patients, while X4IVLs increased only in MCT(-) patients, with X4IVLs of >2 lo...

The task of wear resistance improvement for bearing steels working at high loads in water medium was solved by laser alloying with Sn. The modified zone contains up t o 22 wt.% Sn, which is used as a solid lubricant during exploitation. As a result the bearing race's durability is increased 2.5 times. The combination of laser alloying from a nitrogen jet with surface plastic deformation (SPD) w...

Many components of the storage ring and front ends in the third generation of light sources are subjected to high heat loads from intense x-rays. Temperature rises and thermal stresses in these components must be kept within acceptable limits of critical heat flux and low-cycle fatigue failure. One of the design solutions is to improve heat transfer to the cooling water either by increasing wat...

Industrial adoption of PKMs may be eased by availability of methodologies and integrated tools able to analyze in a short time PKMs of any architecture, providing the key data needed to design the machine. The proposed Virtual Prototyping Environment for PKM Analysis answers to these requirements, quickly estimating not only the reachable workspace, the Jacobian conditioning, but also the actua...

Thin gold films placed in contact on compliant elastomeric poly(dimethylsiloxane) supports weld together. This ;;cold welding'' is remarkable both for the low loads required and for the fact that it occurs under ambient laboratory conditions, conditions in which the gold surfaces are covered with films of weakly adsorbed organic impurities. These impurities are probably displaced laterally duri...