To learn about cooling of gas quenched batches, this paper reports on numerical predictions of local and average convective heat transfer coefficients, and overall pressure drops, on batches of five axially aligned, constant temperature, short cylindrical disks 25 cm diameter, 5 cm thickness with and without a concentric hole, with interdisk spacings of 5–20 cm, in axial turbulent flows of 20 b...

Oxygen gas-liquid mass transfer coefficient was measured in a gas-induced pulsating flow bubble column. Pulsating amplitude had a great influence on kla under pulsating state of equal base flow and pulsating flow, which was enhanced up to 30 % compared with that under steady state; however, it had a negative effect on mass transfer under a fixed low base flow. It was also found that kla had a n...

............................................................................................................................................... 18 INTRODUCTION......................................................................................................................................... 18 EXPERIMENTAL METHODS ...............................................................................

The evaporation heat transfer and pressure drop characteristics of HFC-161 in a horizontal smooth tube with an inside diameter of 9 mm was experimentally investigated. The local heat transfer coefficient and total pressure drop were measured at the heat flux ranging from 15 – 25 kW/m, the mass flux ranging from 100 – 200 kg/(m·s), and the evaporation temperature of 5, 10 °C. The experimental re...

Nucleate pool boiling heat transfer coefficient have been experimentally measured on a horizontal rod heater for various liquid binary mixtures. Measurements are based on more than three hundred data points on a wide range of concentrations and heat fluxes. In this investigation, it has been confirmed that the heat transfer coefficient in boiling solutions are regularly less than those in p...

In this study, condensation heat transfer coefficients of R-410A were obtained in flattened stainless tubes made from 5.0 mm inner diameter round tubes. The test range covered saturation temperature 45 , heat flux 10 °C kW/m, mass flux 100~400 kg/ms and quality 0.2~0.8. Results showed the effect of aspect ratio on condensation heat transfer coefficient was dependent on the flow pattern. For ann...