The overall aim of the research was to better understand the influence of raw material characteristics on the quality of decorative veneer, to identify phenotypes of oak and sessile oak valuable for veneer use, and to promote quality in relationship with sustainable development of Romania’s forests. This paper describes specific aspects regarding wood defects and quality conditions imposed on r...

The fluorescence of porcelain crowns recovered from the mouth of an unknown murder victim, and several control porcelain samples, were examined by fluorescent examination lamps. The fluorescence from two of the control samples was quite similar to that from the porcelain crowns recovered from the victim. To increase the objectivity of the results by quantitative analysis, the composition of eac...

Jacket crowns, metal-bonded porcelain crowns and bridges, made by vacuumfiring dental porcelain, have been considered comparatively stable in the oral cavity. In clinical practice, however, stains, slight surface roughness or abraison are sometimes observed on porcelain prosthetic appliances that have been retained for a long time. But studies related to the durability of such porcelain prosthe...

The differentiation of porcelain from tooh using fluorescence emission was investigated as a basic research for the visual detection of porcelain-restored teeth in mass dental health examinations. The fluorescence spectra were taken from the extracted human maxillary central incisors and five types of porcelain by excitation using the light 380-470 nm. There was a clear difference in fluorescen...

Several studies have investigated toughening porcelain that is layered over a frame or a core. The introduction of residual compressive stress to the surface of porcelain has been shown to be effective to strengthen it. In the present study, nanoparticles of precious metals of silver and platinum (rather than non-precious metals) were used to evaluate if they could increase the fracture resista...

OBJECTIVE This study evaluated the influence of porcelain (VM9, VITA Zahnfabrik, Germany) thickness on the flexural strength and crack propagation in bilayered zirconia systems (YZ, VITA Zahnfabrik, Germany). MATERIAL AND METHODS Thirty zirconia bars (20.0x4.0x1.0 mm) and six zirconia blocks (12.0x7.5x1.2 mm) were prepared and veneered with porcelain with different thickness: 1 mm, 2 mm, or 3...

In dental care, treating anterior dentition esthetically has always been difficult. Numerous restorative solutions, including resin composites, all-ceramic crowns, and ceramic veneers, become accessible with the advancement of materials. such situations, practitioners patients should pick most appropriate option to enhance oral health aesthetic outcomes. Any substance made non-metallic inorgani...

The aims of this study were to determine the fracture origins and crack paths in the porcelain of clinically failed bilayer ceramic restorations and to reveal the correlation between the porcelain failures and material properties. Three clinically failed crowns of each material (bilayer zirconia crowns, galvano-ceramic crowns, and porcelain-fused-to-metal crowns) were collected and underwent fa...

The royal porcelain manufactories in eighteenth-century Continental Europe were sites of production that implemented chemistry in three different areas: manufacture of porcelain paste, preparation of pigments for ornamenting porcelain, and construction of furnace along with choice of fuel for firing porcelain. This paper provides evidence for the Royal Prussian Porcelain Manufactory in Berlin b...

compare the effect of different ceramic thicknesses on degree of conversion (dc) of 3 light-cured resin cements. methods: in this experimental in-vitro study, the degree of conversion of three light-cured resin cements, variolink veneer (ivoclar, liechtenstein), relyx veneer (3m espe, usa) and choice2 (bisco, usa) were evaluated beneath feldespatic ceramic discs (vita vmk master) with a same sh...