in this paper, the results of design and implementation of the subsystems for generating loran pulse are proposed based on method of carrier’s pulse width change. in order to generate the desired pulse, firstly a pwm signal generated and then it is applied to a class-d switching amplifier. the results show that by generating appropriate pulses in digital fpga subsystem for application in switch...

In this paper, characteristics of blushless direct current (BLDC) motor including core loss are analyzed considering pulse width modulation (PWM) of inverter. Input voltage of BLDC motor due to PWM is calculated considering duty ratio and carrier frequency of inverter in order to control torque or speed of BLDC motor. For the calculation of core loss, the input current with harmonics due to PWM...

Pulse width modulation (PWM) has been widely used in power converter control. Most high power level converters operate at switching frequencies up to 500 kHz, while operating frequencies in excess of 1 MHz at high power levels can be achieved using the planar transformer technology. The contribution of this paper is the development of a high-frequency PWM generator architecture for power conver...

Pulse-width modulation (PWM) is known for simple digital-to-analog conversion and motor current control. But up to now, PWM is not known for high speed communication. This paper shows how to implement the physical layer of a fully digital PWM-based communication system. For performance reasons the PWM senders and receivers are implemented using asynchronous logic. The proposed calibration proce...

Power Inverters have a high range of applications not only in domestic appliances but also in industries for performing variety of operations regarding switching and conversion of electrical energy. The purpose of this research paper is to analyze a three phase inverter using PWM topology to obtain a smooth and pure sinusoidal wave form of good quality which ensures better operation for sensiti...

This paper proposes a new topology namely Improved Current Fed Switched Inverter which is derived from the current fed switched inverter. The new topology improves the value of modulation index from its previous topology where the value of modulation index was restricted. The system is suitable for the renewable applications since it draws continuous input current. Single stage high boost inver...

The distortion obtained in the Uninterruptible Power Supply (UPS) output due to increasing use of rectifiers in critical loads an effective strategy is needed to control the output of UPS system. Sinusoidal pulse width modulation (SPWM) and space vector pulse width modulation (SVPWM) are the most popular PWM techniques for three phase UPS system. As compared to SPWM, SVPWM is much effective in ...

This paper proposes five level diode clamped Z source Inverter. The existing PWM techniques used for ZSI are restricted for two level. The two level Z Source Inverter have high harmonic distortions which effects the performance of the grid connected PV system. To improve the performance of the system the number of voltage levels in the output waveform need to be increased. This paper presents c...

Abstract— This article represents the modeling and simulation of a Single Phase Matrix Converter (SPMC) fed Induction Heating (IH) system. The working principle and the control system using Fuzzy Logic Controller (FLC) are elucidated in detail. The performance of the system and their harmonic content analysis of Single Phase Matrix Converter are carried out in MATLAB/Simulink environment. Pulse...