A dynamic analysis model of the unbalanced vibration response a single-rotor system is established to study corresponding mechanism excitation force and caused by deviation rotor mass centroid in this paper, finally achieve combined suppression. First, installation multi-stage rotors during was studied, transfer rotating coordinate obtain vectors at all levels based on traditional stacking asse...

This work deals with the applications of extended Lagrangian-Hamiltonian mechanics on the asymmetric multi rotor system, where the symmetries are broken due to rotor mounted on the shaft with different masses and dimensions. The whole dynamics of asymmetries of multi-rotor system is investigated through extended Lagrangian formalism with a case study. In this work, an analytical model through e...

This paper proposes the use of the Teager–Kaiser energy operator (TKEO) for the detection of a broken rotor bar (BRB) in a squirrel cage induction generator, which is used usually in wind energy systems. The TKEO is investigated using the non-stationary signals representation in the time/frequency domain by sensing the estimation of the instantaneous amplitudes and frequencies present on the st...

This paper addresses the feasibility of using trailing edge flaps to reconfigure a helicopter rotor blade following a failure of the pitch link, which makes the blade freefloating in pitch and otherwise uncontrollable. A coupled rotor-fuselage model is developed which allowed for rotor anisotropy. A new, optimization-based, trim procedure is developed to determine the dynamics of the failed bla...

Broken rotor bars and end-ring are common faults in three-phase squirrel-cage induction motors. These faults reduce the developed toque and increase the speed fluctuations of the motor. Meanwhile, developed unsymmetrical magnetic generates noise and vibration in the motor. Local heat around the broken bars may gradually break the adjacent bars and the motor will be finally out of service. Finit...

An experiment in forced vibration was conducted to study the fluidinduced rotordynamic force on an impeller whirling along a trajectory eccentric to its undeflected position. The prescribed whi l trajectory of the rotor is a circular orbit of a b e d radius. The force measured is a combination of a steady radial force due to volute asymmetries and an unsteady force due to the eccentric motion o...

The structural integrity of the rotors of wind power stations can be monitored by a variety of sensors. However, the power supply of the employed sensors should not be connected by cable because lightning strikes are provoked that way. Therefore, energy harvesting systems are an interesting alternative. Three concepts for electrical power generation by harvesting the energy from the movements i...

The vibration characteristics of a rub-impact rotor system with different parameters are investigated using Hilbert-Huang Transform (HHT)-a relative novel time-frequency analysis method. Firstly, the rotor with rub-impact at fixed limiter is modeled by finite element method (FEM). Then, system simulation signals at different rotating speeds, rub-impact clearances and rub-impact rod stiffness ar...

You work in a characterization laboratory af a MEMS company, and you have to design an electronic board in order to test a given capacitive accelerometer. The application of the sensor is vibration monitoring on a mechanical engine in a specific frequency range (from 40 Hz to 400 Hz). The MEMS device has a mass of 8nK g , a mechanical stiffness of 5N /m and a quality factor Q = 2. The capacitiv...