A titanium–iron intermetallic with minor addition of manganese (TiFe0.7Mn0.3) was processed by severe plastic deformation through high-pressure sliding (HPS). rectangular strip sample embedded in stainless steel and strained under a pressure 4 GPa at room temperature. The hydrogen storage kinetics activation the HPS-processed were significantly enhanced comparison as-received ingot without HPS ...

A conventional twin-roll caster usually casts strips at a speed slower than 2 m/min and roll load greater kN/mm. vertical-type high-speed can cast aluminum alloy higher 10 smaller 550 N/mm due to the effect of large thermal conductivity copper rolls, compared with that steel rolls. However, properties an strip 140 30 are not clear. In this study, Al–5%Mg were loads 88 using caster. The effects ...

The article presents the results of tribological investigations into steel/polymer/steel sandwich material LITECOR® developed by ThyssenKrupp Steel Europe for applications in automotive industry. Friction tests were carried out means a strip drawing test with use special tribotester mounted on uniaxial tensile machine. influence sheet deformation value coefficient friction (COF) was considered....

Abstract A salt spray test was used to evaluate the corrosion resistance of pickling high-strength steel JSH440W phosphating film on its surface, and scanning electron microscope (SEM) energy dispersive spectrometer (EDS) were analyze micro-morphology element content surface defects area sample after test. The results show that enrichment Si, Mn, O elements badly influences film-forming perform...

In article number 2300031, Hua-Bing Li, Zhou-Hua Jiang, and co-workers depict a schematic diagram illustrating the continuous casting process of slabs, along with corresponding temperature distribution after steel strip feeding. This analysis examines progressive changes in morphology, focusing on successive stages rapid cross-sectional area expansion, subsequent sharp decline, oscillation, ult...