the brass tubes with foam cores of alsi7sic3, alsi7sic3fe1 and alsi7sic3fe3 were produced as the crush-boxes with circle and square cross-section. then axial compressive behavior and energy absorption capability of the foam-filled tubes were investigated during the quasi-static progressive plastic buckling. the uniaxial compressive stress–strain curves of the foam-filled brass tubes exhibited t...

The effect of the initial microstructure and intercritical annealing on mechanical properties and work-hardening response of a high-formability low carbon steel were studied. The work-hardening analysis was based on the modified Crussard–Jaoul method. The ferritic-pearlitic sheets showed low strength and high total elongation with the appearance of the yield point phenomenon. The occurrence of ...

The mechanical response of Polyethylene Terephthalate (PET) in elongation is strongly dependent on temperature, strain and strain rate. Near the glass transition temperature Tg, the stress vs strain curves present a strain hardening effect vs strain under conditions of large deformations. At a given strain value, the strain rate has also an increasing influence on the stress value. The main goa...

We report on experiments on the rheology of gels formed by diffusion-limited aggregation of neutrally buoyant colloidal particles. These gels form very weak solids, with the elastic modulus, G0svd, larger than the loss modulus, G00svd, and with both G0svd and G00svd exhibiting only a very weak frequency dependence. Upon small but finite strains g , 0.45 the elastic modulus increases roughly exp...

Vast experiments have demonstrated that the external specimen size makes a large difference in the deformation behavior of crystalline materials. However, as one important kind of internal planar defects, the role of grain boundary (GB) in small scales needs to be clarified in light of the scarce and inconsistent experimental results at present. Through compression of Cu bicrystal and its count...

Constitutive models dealing with the thermal and visco-plasticity of metals have seen wide applications in automotive industry. A basic plasticity fracture characterization a 1.5 mm thick DP780 dual phase steel sheet based on uniaxial tensile (UT) experiments seven distinct material orientations is complemented by low (?0.001/s), intermediate (?1/s) high (?150/s) strain rate notched (NT) shear ...

In this paper, the development of a new variation of Engineered Cementitious Composite (ECC) that aims to combine tensile ductility with self-sensing ability is described. ECC is a new type of high-performance fiber reinforced cementitious composite that exhibits strain-hardening under applied tensile load while resisting fracture localization. The self-sensing ability is achieved by incorporat...

• Performed static and dynamic indentation experiments Characterized deformation mechanism through 3D DIC Observed pronounced non-monotonic strain rate effects Formulated enhanced Deshpande-Fleck plasticity model Incorporated both strain-rate hardening softening The safety of electric vehicles under crash event depends on the mechanical behavior Lithium-ion cells large at high rates. Here, an e...

CP Ti was mirror-polished and then abraded with waterproof SiC papers of two different grit sizes: 16 and 3 microm. As-polished and abraded surfaces were characterized by means of EPMA, XPS, XRD, and hardness test. Oxygen in the mirror-polished surface was uniformly distributed at the lowest level. Comparatively, abrading with SiC papers increased the surface oxygen amount and hardness. Owing t...

Characterisation of model asperity flattening under longitudinal subsurface elongation is presented with a variety normal pressure, flank angle and strain hardening behaviour. A systematic investigation outlines an optimal specimen design to ensure homogenous deformation field in the workpiece stress-strain conditions, which are typical sheet metal forming. Asperity increases reduces necessary ...