The incorporation of an organic group into sol-gel-derived silica causes significant changes in the structure and properties of these materials. Therefore, the thermal treatment of organosilica materials may require a different approach. In the present paper, kinetic parameters (activation energy, pre-exponential constant, and reaction models) have been determined from mass loss data for the de...

The thermal degradation of acetaminophen is studied via conventional accelerated aging studies by initially thermally stressing the compound at temperatures between 160 degrees C and 190 degrees C and measuring the rate of decomposition by reversed-phase high-performance liquid chromatography. Rates of decomposition of the compound in the dry state and the activation energy for the process are ...

Evaporation kinetics of fused silica were measured up to ≈3000K using CO(2) laser heating, while solid-gas phase chemistry of silica was assessed with hydrogen, air, and nitrogen. Enhanced evaporation in hydrogen was attributed to an additional reduction pathway, while oxidizing conditions pushed the reaction backwards. The observed mass transport limitations supported use of a near-equilibrium...

Quantum well (QW) resonances are identified in Ag films on an Fe(100) surface and are used in low energy electron microscopy to monitor film morphology during annealing and growth. We find that Ag films thermally decompose to thicknesses that are stabilized by QW states at the Gamma point. Novel growth morphologies are also observed that highlight the competition between kinetic limitations and...

Figure 1: Raw data with calculation Differential Scanning Calorimetry (DSC) is used to measure heat flow into or out of a sample as it is exposed to a controlled thermal profile. DSC provides both qualitative and quantitative information about material transitions such as the glass transition, crystallization, curing, melting, and decomposition. For some of these transitions, DSC can provide no...

the effect of mechanical activation on structural changes and kinetics of carbothermic reduction of hematite with graphite was studied in this research. hematite powder mixture with graphite (with stoichiometry ratio c/o=1) was milled for the time periods of zero to 50 hours, and the structural changes were studied using x ray diffraction (xrd). the effect of mechanical activation on the kineti...

Differential Scanning Calorimetry (DSC) is used to measure heat flow into or out of a sample as it is exposed to a controlled thermal profile. DSC provides both qualitative and quantitative information about material transitions such as the glass transition, crystallization, curing, melting, and decomposition. For some of these transitions, DSC can provide not only the temperature at which the ...

The unimolecular decomposition of 2,5-dimethylfuran (DMF), a promising next-generation biofuel, was studied at the CBS-QB3 level of theory. As most of its decomposition routes remain unknown, a large number of pathways were explored: initial C-H bond fission, biradical ring opening, H-atom and CH(3)-group transfers involving carbene intermediates. Based on the computed potential energy surfaces...

A novel energetic salt of Bis(semicarbazide) 5,51-bitetrazole-1,11-diolate [2(SCZ) ̈BTO] was synthesized by using semicarbazide hydrochloride and 1H,1’H-5,5’-bitetrazole-1,1’-diol (BTO) as raw materials, and its structure was characterized by elemental analysis, Fourier Transform infrared spectroscopy (FT-IR) spectroscopy, 13C NMR spectrum and mass spectrum. The single crystal of the title salt ...

Mg(OH)2 nanoparticles were synthesized by a rapid microwave reaction. The effect of sodium dodecyl sulfonate (SDS as anionic surfactant) and cetyl tri-methyl ammonium bromide (CTAB as cationic surfactant) on the morphology of magnesium hydroxide nanostructures was investigated. Multi wall carbon nano tubes was organo-modified for better dispersion in cellulose acetate matrix. The influence of M...